Blank display on proform 650 cardio crosstrainer

SOURCE: I've bought a Proform 900 Crosstrainer but it did

For the paper-version ($7.95), use this link:

http://www.online-owners-manual.com/pfccel45011.html


They don't offer a downloadable manual for the exact model, but offer a comparable model's manual here:

http://www.online-owners-manual.com/drel45010.html


Hope this helps!

-- RT

PS - Don't forget to vote!

Testimonial: "thanks for your time and info - much appreciated!"

John Mazmanian

• 832 Answers
• Posted on May 18, 2010

SOURCE: is there a user manual for crosstrainer 470

Go to iconservice.com click on manual input manufacturer then this model # PFEVEL27860

SOURCE: Have purchased a used Pro Form 900 Cardio Cross Trainer

If you can hear the adjustment motor running the problem could be related to two things:
1. Broken or stretched resistance adjustment cable.
2. Broken bracket for the magnet return spring.
If the resistance is on maximum all the time the second issue is most likely the cause.

John Mazmanian

• 832 Answers
• Posted on Jul 16, 2010

SOURCE: Proform Crosstrainer 5.0 Treadmill

ICON CALIBRATION INSTRUCTIONS- INCLINE
1) Press the Stop and the Speed Up keys down while inserting the safety key. If this doesn’t work, click on the help topic entitled “Alternate Calibration Codes” for key sequence instructions to enter calibration.
2) Press the Stop key one time. The Time window should read EP:2P. Some newer models may also say FP, Pass, or the like. This means that it passes the EPROM test.
3) Press either incline key and the incline will calibrate automatically.
4) THIS IS A VERY IMPORTANT STEP BECAUSE YOU WILL GET AN ERROR MESSAGE IF THIS STEP IS SKIPPED.After completing calibration of incline, press the Stop key and then remove the safety key.

ernesto cuadra

• 12223 Answers
• Posted on Dec 26, 2011

SOURCE: when I turn on my proform 650 cross trainer the display shows 8s and flashes brightly one time and then goes blank

1) tRY TO exchange new batteries by news one.

2) Use your calibration software by easy diagnostic and fix it.

3) Tight the flexible cord from key piney vs display board.
4) Tight the connector from display board vs, Main Motor board,

5)aTTACHED THE diagram for sensor reed switch adjusted by 1/8"

6) Test the main motor controller board for 115 Vca,
+5vdc FOR OUTPUT GOING TO DISPLAY BOARD.
7) tEST THE transformer see the tips.
8) Test the power supply for +5Vdc see if there are some componnet like resistor, capacitor, diodes, etc Burns.

http://www.fixya.com/support/r10724803-measure_voltage_in_transforme_fitnessSee the block diagram for easy diagnostic that I did for people like your. Sincerely. Happy New Year G-d bless you.

ernesto cuadra
managua, nicaragua,