How do i add freon to fedders model # A6X05F2B

You can recharge the compressor with R134a refrigerant gas, but not with coolant. But, the compressor will have to be purged of any existing refrigerant gas, before recharging with new gas.You shouldn't mix old with new, because depending on the age of the unit, it may still have Freon in it. Freon has been banded by the EPAand doesn't mix with the new gas.

Hope this helped answer your question. Thanks for choosing FixYa.

clean the filter . make certain its tilted ot the outsid eby about 1 inch. let me know if htis does not solve it or if it does thank you jon

Hello, you can add freon by installing a piercing valve on the low side of the system. Before adding freon I would check and make sure the air filter and both coils are clean. If everything is clean then most likey the unit has a leak and is low on freon.

Make sure the coils are not dirty,if they are not dirty,add freon to the system,not much,feel the evaporator,when the evaporator is cool all over,and the condenser is warm all over,there is enough freon,add very little at a time,this system does not hold much freon,if this was helpful,at all,please rate,thank you.

I have a fedders a6x05f2b and the compresser comes on but the fan does not. What can I do?

you either have internal thermostat problems, selector switch problems or youve got a freon leak. to determine a freon leak is the units coil freezing up or is it dirty check filter first take unit out and to car wash remove housing and give it a bath dont plug it back in until its dry.hope this fix works if not work your switches remember they set in one position most all the time if freon call a tech

With a glass cutter, you could cut the glass to the correct size and using some angle aluminium strip and some silicone, then seal between the unit housing and glass. Hope this helps

Hi, yes right on you plug, if not, make sure there's voltage in receptacle, check your plug for any damages, your fan should be blowing, it seems to me you have no power in receptacle, check house panel for trip breakers, or you will have to go further, by removing front cover, with power off, and check master switch, sometimes master switch goes bad, if you don't want to go further call mechanic.good luck.

GO TO WWW.FEDDERS.COM AND DOWNLOAD IT U NEED TO HAVE ADOBE 9

Unplugged unit first. Take control panel out but dont unplug wiring. Cut Firth wire out from the center on the touch pad six wire plug. Cap both ends and plug back in. now unit will run on high cool and turn it on and off by plug and unplug