Network Printing (LAN)

Your machine mite have been set up under the administrator setting instead of your access.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

1-Press "Utility/Counter" button from the control panel.
2-Press "Administrator settings"
3-Enter "Admin Password"=12345678
4-Press "END" button on top right corner of the screen.
5-There are two settings now, Admin1 and Admin 2.
6-Press Admin 2. the network settings
7-Now press "IP settings" in this option there will be two settings one is obtain IP auto and other is put IP manual.
in network settings you will see all the other options such as ping confirmation, DNS HOST, DNS SERVER ADDRESS, DHCP ON/OFF, SMTP etc.

Simply uninstall the printer.Restart your PC.Now again install the printer.Use new driver instead of previous drivers.Ping confirmation from PC.Ping from Machine.If connection is okay then there is no need to reset the machine.There is network problem.

First of all bring your machine on network.All you have to do is to just connect the network cable to it.Now press these buttons,Utility/Counter,Check details or details,Now select Administrator,enter admin password which is 12345678.Press enter.Now press NETWORK SETTINGS,In this option go to IPv4 setting. In this option enter IP address manually and put it on manual setting.Now press Details settings, then press Ping confirmation.Enter the IP which you want to ping and press Start button.This is how you can ping any ip address frm machine and bring your machine on network.

You need to set up a new port Usb on the network printer and then install it.

if you are adding it to your network... then you are doing ip printing... verify that nobody else on the network has the same ip address by unplugging the network cable from the copier and doing the following... goto start... accessories... command prompt... (black and white blox...) ping the copier... lets say ip is 192.168.168.168 then you ping it by typing ping 192.168.168.168 and hitting enter... if you get 4 time outs then ip is good... next step is to reinstall your print driver...

I’m happy to assist further over the phone at https://www.6ya.com/expert/norman_d2fa496dce30c65d

Some network interfaces have been found to be defective. Try printing from parallel or usb until you can get a replacement network interface.

check the setting for ur network
check ur lan card
check ur lan connectors
check ur lan cable

do you set the paper size ??

Hi How to check the print server is in the wireless network or not!! Check under the Router Setup page Router's ip address... Check if you are able to ping the Print Server Ip address....Since it the router will assign a ip address from DHCP range.. If you are able to ping the router's ip address and the print server ip address then the print server is in the Wireless LAN... Try the following steps. 1. Go to run and type "cmd" press enter 2. type ipconfig. 3. Check the range of ip address...if its 192.168.0.XX 4. Try pinging that ip address.. 5. If able to ping the router and print server.. Then the wireless network is fine... Somehow some of the printer's don't work with some of the print servers.. Check if D-link does support the printer or not!!!! for this particular model of the router...