Display light flashes on and off won/t start

Diane,

Fisrt try this fixes a few of these issues....

Unplug it (or turn off power at the circuit breaker), wait some time for the electrical charge to clear out of the dryer (usually 1 to 5 minutes at most), and then power it up again.

If you aren't sure whether Control Lock is on, press a cycle button on the keypad. If Control Lock is on, the light will blink three times.
Turning off Control Lock:

1. Press and hold the Lock Button for four seconds. The lock light will disappear.
2. Once off, you should be able to start your wash cycle.

Note: If Sleep Mode is on, turn that off first, then turn off Control Lock.


Like many other electronics, you may need to reset the dishwasher control panel by turning it off, waiting, then turning it back on.

1. Press the OFF button.
2. Disconnect the dishwasher from its power source by unplugging it or by turning the circuit breaker off at the electric panel.
3. Once disconnected, wait one minute, and turn the power back on.

Try unplugging it and wait 5 minutes before plugging it in again. Might work

http://www.ehow.com/info_12203962_check-dryer-thermistor

Have u tried unplugging it for about 2m and plug it bk in that will master reset everything like u just bought it and see how that's works out

Is the security light flashing? If so, turn ignition on and wait for 10 minutes and light should stay on solid. Then try and start the car without turning the ignition back off. Then turn off ignition and wait 1 minute. Then turn ignition on and see if security light is flashing. If not try and start your car. If it is flashing, try waiting again with just the ignition on and see if it goes out.

when I turn my printer on (Epson Artisan 700 series printer) it waits for about 5 to 7 seconds and then displays a message that says "A scanner error has occured. Please see your documentation". Then all the lights start flashing, And then I cant do anything, but turn the printer off.

I have turned it off and unplugged it and tryed again always same result.

[email protected]

Most of them won't restart right away. Wait ten minutes or so before you try again. If that doesn't work, unplug it, wait ten minutes, and then try again. You could also plug a light into the outlet to make sure it does have power.

I have the same problem. The only way to get the TV to come on is to unplug it, but once you get it back on it turns itself off again in a few minutes.