How can solve error p 5 idc sensor in konica minolta bizhub c450

Replace the Black drum and developer unit (P9) (P16) and clean the IDC forward sensor(P5) (Requires removing the Transfer belt)
L4 Black Drum Rotation well passed its life.

one of the IDC sensor is bad or dirty must remove the transfer belt then slide the cover that protect the two sensors and clean both. Recommend a tech come out and do it or tone of the sensor is bad

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Remove the transfer belt. Then right below the fusing unit right where the edge of the transfer belt is located when normal installed right below where the edge of the belt would be. Are two sensors they are cover with the belt out and door open so you will have to GENTLE open them with your fingers and GENTLE clean them DO NOT USE AVACUUM CLEANER THE STATIC ELECTRICTY from the vacuum cleaner can destroy the sensors.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Clean them located under the transfer belt when it is removed. after which you need to accurate the sensor cover protectors manually the clean the sensor with a try cloth no static electricity or you will cause the sensor to be destroyed..

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

IDC sensors are located under the transfer belt on the right sid eof the machine. Belt must be removed to clean sensors. Once belt is removed sensors are located on a black plastic frame and have slideable covers that can be moved by hand to clean sensors. There are 2 sensors one machine front and one machine rear.

Sir/Mam
Clean them located under the transfer belt when it is removed. after which you need to accurate the sensor cover protectors manually the clean the sensor with a try cloth no static electricity or you will cause the sensor to be destroyed.. recommended a tech do this unless you known what you are doing.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

I have minolta c450 show error c d370... how can I solve this problem... plz reply me with solution.

Go to service mode and click on counters, then select Service call counter, there you will find the complete error code list for bizhub c450.

here is the link
http://www.ebookbay.com/ebook/938/konica-minolta-bizhub-c250-sm

if you have any problem contact me.

Download

http://kmbs.konicaminolta.us/content/products/models/bizhubC450.html?info=Manuals