Goes bit then stops press reset goes again then stops

oL is an Overload error. Try running a cycle empty.

If oL (overloaded) appears in display, the load too large. If an overload is detected, the washer will drain any water and detergent in the washer. Remove several items and add HE detergent. Close lid and press START/PAUSE.

oL - Error Code - Washer - Product Help ' Whirlpool

https://www.google.com/search?q=whirlpool+cabrio+ol+error

..

Bad control board.

There are four buttons - Mode, Light, Start and Reset.
Press the Mode button once and it enters a day setting mode. Press Mode again and it goes into an alarm set mode. Press Mode again and it goes into a time display mode with the seconds flashing. Press reset to toggle through seconds to minutes to hour to day. Press the start button to increase a value. Press Mode again to resume normal functions.

Needle should move a little bit upon stop/go.If it is a lot would have to say it is the potentiometer in the sending unit fuel pump.

Information taken from: http://www.idavette.net/tech/oilreset.htm

[quote]
The "Change Oil" indicator is reset by using a sequence of Driver Information Center (DIC) key presses as follows:

1. Turn ignition "ON", but do not start engine. (ALDL pin "G" should NOT be grounded.)
2. Press the "ENG/MET" button and release, then, within 5 seconds, press it again.
3. Within 5 seconds of Step 2, press and hold the "GAUGES" button. While the button is held, the "Change Oil" indicator will flash.
4. Continue holding the "GAUGES" button until the "Change Oil" indicator stops flashing and goes out, indicating successful completion of the reset cycle. This should take about 10 seconds.
If it does not successfully reset, turn ignition "OFF" and repeat the procedure from Step 1.
[/quote]

It sounds like a wheel sensor is failing, this will trip the ABS and cause the brakes to feel a bit weird. You will need to press the brake harder to stop if the ABS getts tripped.

The F300E Honeywell Electronic Air Cleaner should only be lit when the fan is running. The light goes out when fan stops, this is normal.

throttle position sensor most likely...

My alarm is triggered when I leave the windows down a bit. There's a motion sensor for the interior of the car (I think it's thermal), so when a breeze blows cool outside air through the car's hot interior, it triggers. The interior sensor can be turned off by pressing the button just behind the driver's door and in front of the rear door. Try turning that off and see if it makes a difference. Post a comment with the results.