Bluray not responding to remote and manual operations

Get new batteries and test it with a digital camera or AM radio - check google for procedure. If remote is ng you will have to replace it. Try ebay eBayeBay

Have you tried pulling the plug for a minute? Also try the eject button directly from standby.

if you want to confirm if the transformer in the power supply is also bad you have to make a voltage checking. turn on the dvd player and make a voltage checking at the output at the power supply board.

hello erick 5412,
Just a simple way , no need to program .
If you connected you TV with bluray use a HDMI cable, you can operate TV and bluray in one remocon. Set your HDMI CEC on, it will initial connection a moment. After that connected you can operate tv and bluray at a time , like power on off, play, etc.
Thanks.

There is an infrared sensor inside the tv to receive infrared signals transmitted by the infrared signal generating light emittin diode fixed on your remote control. Either the sensor inside the tv or light emitting diode in the remote controller faulty, remote function will not work. For manual operation troubles, check the wall power socket of plug of the tv is faulty, loose contact etc.

On blu ray remote control hold down TV Power+01 at the same time. If the TV turns off the controller is programmed. If not, try TV Power+02, +03, +04, +05, +06, +07, +08, +09. Different TV BRAND??? ...TRY http://remotes.com/remotes/documents/Samsung/AK59-00104K.pdf

Here you go. This will work with most all universal remote controls. If you don't have the code do the following:
Automatic Programming
With automatic programming, the remote control tests all the codes available on the Code List and assigns the correct code for the selected device. Although this method can be more time-consuming, it eliminates the need to look up codes and enter them manually.

1. Turn off the device with which you want to use the remote control.

2. Press and hold the corresponding button on the remote control
(TV, VCR, SAT, DVD, CAB or AUD) until POWER INDICATOR illuminates. It should take a couple of seconds for the light to remain solid. The remote control is in programming mode.

3. Press and release power button. The POWER INDICATOR flashes once and stays on indicating the unit is in Power Scan mode.

4. Press CHANNEL up or CHANNEL down repeatedly until the device turns on.

5. When the device turns on, press OK to store the code.

Note:
• To exit without storing the code, press BACK.
• T he unit will search for the next code or the previous code if you press
CHANNEL up or CHANNEL down after the device turns on. (go slow you need to press OK when the TV turns on) if you mess up turn TV off and start over.
6. Press any other button. If the device responds, the remote control has been programmed. If the device does not respond, repeat steps 2-5.

Fill free to ask me questions about anything..........................

I just answered this question. Again, for more information, please visit my website at audioserviceclinic.com. Thank you.

Try resetting it.
Remove the batteries and hold down the POWER button on it for 30 secs. Then replace the batteries with fresh ones.

Sounds like a bad power board. They have random meltdowns all too often. Usually the cause is an overheated transformer caused by power transistor short outs. Possibly sell it. Could get over $100 for it if sold online.