My skyworth 32E63 doesnt the only show red or orange color in the switch botton ?

moved you out of computer to TV and best match SKY

Hello Joyce, it would be nice if you indicate which Skyworth TV model you have
For what you say, you might need a firmware update, or try to leave it disconnected from the power network for 10 minutes and reconnect it, if it stays the same, try to update the Firmware, enter the Skyworth page, look for updates by the model of your television
To download the update use a new flash drive, once downloaded, put it on your TV, disconnected from the power network, then connect and wait for it to do the whole process, when it finishes updating, it should turn on, as it always does.
If that does not happen, I suggest you consult a specialized technical service
I hope you can solve the problem
Greetings Franco Dosil
Hola Joyce, seria bueno que indiques que modelo de TV Skyworth tienes
Por lo que comentas, podr?a necesitar una actualizaci?n del Firmware, o prueba dejarlo desconectado de la red de energ?a por 10 minutos y vuelve a conectarlo, si sigue igual, intenta actualizar el Firmware, ingresa a la pagina de Skyworth, buscas actualizaciones por el modelo de tu televisor
Para descargar la actualizaci?n usa un pendrive nuevo, una vez descargado, lo pones en tu TV, desconectado de l red de energ?a, luego conectas y esperas que haga todo el proceso, cuando se termine de actualizar, deber?a encenderse, como lo hace siempre
Si no sucede eso, te sugiero que consultes a un servicio t?cnico especializado
Espero puedas resolver el problema
Saludos Franco Dosil

Try using your remote to over/ride that message.Put in 0000 to reset your tv back to the factory mode.

high voltage regulation problem. when high voltage gets too high protection circit kicks in and shuts off tv. since high voltage is too high, you will see a glow with horizontal retrace lines. if you see red, green, and blue lines your convergence ic's are overheating. suggest local service center

On regulator, top down:brown, orange, white, dark blue.
Top down again: field on alt...,"r" on alt,... to battery,... to resistor that goes to acc side of ign switch, and through dash light to run side of switch (Same wire splits on it's way there) different if transistor regulator or if regulator is in the alt.

Yes this is a good list of the voltages to be expected from a newer power supply on just the main header

THE IS A BOTTON FOR THE ALIGNMENT UNDER THE POWER BUTTON. CLICK ON IT AND SEE IF IT CLEARS. IF THAT DON'T WORK LOG ON TO THE WEBSITE BELOW AND READ ABOUT THE COLOR ADJUSTMENT FOR THE SCREEN VOLTAGES. IF THAT DOESN'T CALL A PREFERRED SONY REPAIR SHOP FOR ADVICE.

http://www.somelifeblog.com/2007/06/sony-projection-tv-red-line-repair.html

as other color are ok(blue&green)& no red colour.please check as follows. 1 check supply to red video transistor. 2 check for loose crt base. 3 check for loose connector 4 check components related to red video ckt.& cathode ckt. 5 check for red signal is coming to red video ckt. 6 check red cathoe voltage. 7 signal processor ic.