Front load washer displays f 24

SOURCE: maytag epic

hi there,

the FH error means it's either you have a drain problem if there is water in it or if if there is now water in it, make sure that both water inlets are turned all the way up. check to make sure that you don't have any water leaks anywhere visible.

SOURCE: my front load washer displays an f28 error code

See the FixYa post:

http://www.fixya.com/support/t800390-f28_error

Sivaranjini

• 241 Answers
• Posted on Jun 22, 2009

SOURCE: Maytag Epic giving F11 error code!

ths.gardenweb.com/forums/load/.../msg1012004912002.html

Terence Fourie

• 909 Answers
• Posted on Sep 21, 2009

SOURCE: Maytag Epic Z front loading washer spin cycle very loud

your bearings and seal need to be replaced.

SOURCE: what does the error code Sd mean on my Maytag Epic

Hi

Thanks for using FixYa. Error 5d/Sd means too much detergent was used. Try the following procedure---

- Run the unit through a RINSE/SPIN cycle.
- Run a NORMAL cycle without adding any detergent.

This should clear the unit of the excess detergent. If still the problem persists, then please check the following things--

1. Check the drain hose and make sure it is not plugged or kinked.
2. Unplug washer or disconnect power.
3. Check wire harness connections to the drain pump, pressure switch, and Central Control Unit (CCU).
4. Check/clean drain pump filter of foreign objects.
5. Plug in washer or reconnect power.
6. Check drain pump.
7. Check the pressure switch.
8. Verify CCU operation by running a Diagnostic Test or any cycle.

Please accept the solution if the issue is resolved post a comment for further assistance.

Thanks
Rylee