Instructions to get access to the drain pump for currys essentials cdw60w10

Hi Susan.
try this google link out might help you out.
https://www.google.com/search?q=curry+essentials+dishwasher+won%27t+come+on&rlz=1C1AVFC_enGB797GB798&oq=curry+essentials+dishwasher+won%27t+come+on&aqs=chrome..69i57.4490j0j9&sourceid=chrome&ie=UTF-8

I had this and it turned out that the float switch had been trigger due to a little leak.
I tipped the unit on its side and unclipped the black plastic service panel. The float switch is housed in this panel on mine so I needed to pull the microswitch out to be able to completely remove the panel.
I noticed some scummy stuff around the seal for the impeller of the drain pump so I twisted that loose and cleaned the seal with soapy water. I made sure that the float switch reservoir was empty before putting it all back. It is working again but that doesn't mean the seal is working properly. Only time will tell. At least least you know where to look now.
My model is a CDW60W16 Curry's Essentials.

Partmaster.co.uk has the Curry's essentials CDW45W16 dishwasher manual. The direct link to the manual is https://www.partmaster.co.uk/images/mediator/1513/currys%20essentials%20cdw45w13.pdf . I found this through a Google search for CDW45W16 manual.

I hope this helps.

Cindy Wells

see
http://www.manualslib.com/manual/845521/Currys-Essentials-Cdw60w10.html?page=15
apparently it is done by the position of the salt reservoir and it is not mentioned anywhere in your user manual for the cdwtt11
a good place would have been on page 18 but it is not mentioned.

sounds like your filter is clogged or water pump

Hi my dishwasher isn't draining it's flashing 2 lights 3 and 4 I have tried rincing it with pressing the start play button but not sure it's draining it completely but still doing it I don't know what to do

Don't buy same problem 2nd time!!!!!!!!!

Just installed a CDW60W16 at my daughters house. worked ok empty but as soon as it was loaded the glass icon lit up and beebs. when I turned it over to take a look at the float switch I noticed that the levelling legs were all screwed in so the base of the machine was sitting on the floor. so when the machine was loaded the pressure switch operated as it was being pushed up by the floor. I unscrewed the legs a few turns to allow an air gap between the floor and base of the machine and all working fine now. on checking the installation instructions it only mentions loosening the legs to level it if required which is wasn't. maybe the manual should give instructions to unscrew the legs a few turns to prevent this

Look for free operation manual downloads online.

ESSENTIALS CDW60W10 the 2nd light is flashing then it flashes and bleep for about a minute before the machine stops...I cant find my user manual anywhere..need my dishwasher working with my family!!! plz help!!! :(