Ush driver/touch senser

Have a dealer run your VIN #

You can learn all about what your car has
off the assy line

You can find it from your computer manufacturer or if your computer running Windows OS, you can follow this steps.
1. Open control panel and go to Device Manager.
2. You will something like warning sign.
3. Right-click on that and click update driver software.

Top drivers side of transm.bell housing

Coolant temperture senser can be unplugged or bad. Coolant can be too low to touch senser. Coolant can be too much water and is'nt circulating as it's frozen and where the senser is it is still cold. The senser is in the left rear of the engine facing the firewall it has a two wire weathertight connector unplug the senser and with a papaer clip ground the wire and look to see the gauge go all the way if it does the gauge and wire are good and the senser or the water getting to it is'nt hot.

I take the air conditioner compressor out of the way and set it aside with all the lines still connected. the fuel filter and it's bracket has to be unbolted and moved up and towards the driver side I don't disconnect any lines from it either, I just raise it a few inches and hold it with a rubber cord. I use a ball ended allen wrench to take the two bolts out and as thier easy to drop I use a magnet touching the wrench to keep from dropping the bolt. I've been luckly with the washers as thier stainless and the magnet hardly picks them. I've got long long nosed pliers and I pick the stuff out as if you drop them thier going to the bottom of the valley and all kinds of parts have to be removed to get them out. with the bolts put up you can grab the senser with long nosed ring ended pliers, other wise you've got to remove the brackets on the front of the motor that hold the belt tensioner and the air conditioner compresser. Insertthe new senser with the pliers that you removed the senser with and have the bolts and washers in it, as you set the senser in use the ball ended allen to start the bolts before you set the senser all the way in. If this sounds hard to do with out dropping someting and those that watch me do it, say they know that their not steady enough do do this. So you might be looking for someone to hire to change it. Get a price first I do it for $100. In Lexington Ky.

The vibration may not be the mounts but the motor missing. What the motor with the hood open. Have your driver put the unit in gear and see how much things move touch the engine and feel the unit does the engine run smothly or does it need a tune up or vacume leak fixed. The exhaust system may be touching the car somewhere and it's transferring noise and vibration. Air conditioning lines and fuel lines can do it too. Is the check engine light on? Mixture problems can make the engine chuggle and vibrate more than normal. oxagen sensers can cause mixture ans can temperture senser lies. Even an opened too much therostate can make the system think that its cold and turn up the fuel till the motor shakes. fouling plugs and causing fuel ecomony problems and low performance problems.

if you bought your computer brand new from a manufacturer such Dell or HP i am sure it came with the recovery disk and all the drivers you need....but after installing all your drivers and still does not work try going to the manufacturer's website, look for support then search for your computer model and all possible downloadable drivers and updates....good luck

Loose connection to the senser wiring or light or light or a  bad  senser itself. Bypass sencer and if the light then stays on, the senser is bad and wil need to be replaced..

u have to install driver then it will works

Yes, i have same problem.i drop my phone and the button half not work at all. any help? thank you