Need wiring diagram for a security camera cat.no.: 49-2516

Identify Components: Before starting, make sure you have the ignition switch and necessary wiring harness.

Disconnect Battery: Ensure the battery is disconnected to prevent any electrical accidents.

Locate Ignition Switch Wiring Diagram: Obtain a wiring diagram for the ignition switch and the Caterpillar 3116 engine. This will help you identify the correct wires to connect.

Mount Ignition Switch: Mount the ignition switch in a convenient and secure location within the vehicle.

Connect Wires: Using the wiring diagram, connect the wires from the ignition switch to the corresponding terminals on the Caterpillar 3116 engine. Typically, the ignition switch will have terminals labeled for various functions such as ignition, accessory, starter, and battery.

Test Connections: Once the wiring is completed, double-check all connections to ensure they are secure and correctly wired.

Reconnect Battery: Reconnect the vehicle's battery.

Test Ignition: Turn the ignition switch to the "ON" position and verify that electrical components such as lights, gauges, and accessories are functioning properly.

Start Engine: Attempt to start the engine and ensure that the starter engages and the engine cranks properly.

Final Checks: After successful installation, perform a final check of all connections and ensure that there are no loose wires or potential electrical hazards.

Help in the link and on the images tab.

https://www.google.com/search?q=bunker+hill+security+camera+wire+color+diagram

..

Yellow is for the microphone
Blue is for the camera
White is the COMMON GROUND
Orange is the power (7.5 VDC @ 300 mA (9 VDC will work))

Link to the user manual: http://manuals.harborfreight.com/manuals/47000-47999/47546.pdf

Direct link both pictures are zoomable

http://www.arcticchat.com/forum/attachments/z-zl-zr-zrt-tcat-ext/139505d1198506607-1992-wildcat-wiring-diagram-scan0013.jpg

http://www.arcticchat.com/forum/attachments/z-zl-zr-zrt-tcat-ext/139506d1198506633-1992-wildcat-wiring-diagram-scan0014.jpg

8 pin RJ45 (8P8C) male connector
at the camera output

LG LVC-CY100NM Color Security Camera with 8-pin RJ45 (and other cameras for the LSP-M1017M Dual Quad Observation Systems by LG)
Pin
Number Pin
Name Description 8 SPK Speaker (Hot) 7 VID Video Out 6 GRN Ground 5 SPK- Speaker (cold) 4 AO Audio Out/Alarm Out 3 VDC 12VDC 2 N/C RS-485- 1 N/C RS-485+ Note: Pin numbers are labled backwards in the manual (corrected above).
The camera is adaptable for use in any composite video application with the use of a balun.
on the output. I had noise-less video and clean audio across a 350 foot run of cat 5e.

If you have duraseal connectors the wires can be waterproof again

Did you try the bulldog website they have wiring schematics for many vehicles. They may be able to assist. in finding the info you need.

I HAVE A SECURITY CAMERA GOT WITH THE WIRES RIPD FROM BACK OF IT 4 WITH WIRES 1 RED 1 WHITE 1 YELLOW AND 1 THICK BLACK WIRE HOW CAN I REWIRE IT?????