Can get configuration addess to work

Computer user. Can't get to take your emails address is not a question and thus unless you can rephrase your question, there is no probable answer.

D-Link DES-1008D 8-Port Ethernet switch is unmanaged switch which can only support 10/100 MBPS.The DES-1008D is a passive switch which means there is no way to configure the ip address and no need to.

make sure you can access the router configuration page

change you computer ip addess to match the ip address range of the router

ex if router is 192.168.1.1
set computer ip to 192.168.1.2
subnetmask 255.255.255.0

and set default gateway and dns server address to gataway address

geateway 192.168.1.1
dns server 192.168.1.1

try it most probably you need to make sure you have configured your adsl user name and password and other settings in you router since you have rested it

1.

Control Panel
Network Connections
Wireless Connection
Properties
Make sure Internet Protocol TCP/IP is set to "Obtain an IP address automatically"

2.

Start/Run
CMD<enter>
ipconfig /release<enter>
ipconfig /renew<enter>

Try: Network Settings --> Settings and Connection Status List

Connect the computer to LAN port one of the router using an Ethernet cable, access the configuration page (ie 192.168.1.254), configure the router as Dynamic IP, Configure the wireless network as (WEP or WPA), Check the IP address of the WAN section.

Note: If you have an IP address to the WAN section the Internet connection is working, Connect through the wireless network by finding the wireless network name was been created to the router.

EMC offers a great documentation site.
Here is it:
http://www.emc.com/microsites/clariion-support/ax150/install.esp?redirect=true

You can select Install and you can create a great customizes doc for installation steps.

Generally you can configure AX150 from a web based interface.
Enter the ip addess of the storage processor and a java application will appears.
You should do the following:
1. Create raid groups
2. Create LUNs on raid group
3. Register the hosts
4. Add hosts and LUNs to a storage groups

if you are using an ethernet cable make sure its connected directly into your Modem and not a port in your PC

Check if your wireless router is configured properly. try to reset the router to the default sitting