Dishwasher will not run - KitchenAid 24 in. KUDS01FLSS Built-In Dishwasher

Common solutions for: Kenmore Dishwasher will not start. The door switch prevents the dishwasher from running and working while the door is open. If the door switch is defective, the switch will stop the dishwasher from running even when the door is closed. If the thermal fuse has blown , it will prevent the dishwasher from starting.
Make sure your dishwasher is fully and also securely plugged in and that the circuit breaker switches haven't been tripped. .It also houses the door latch switch that provides the power to the dishwasher controls. If the dishwasher door isn't closed properly, the dishwasher won't receive power to finish a wash cycle You could call a repair person that fixes dishwashers to have a look at it and see what the problem is with the dishwasher

For regular monthly maintenance fill the dishwasher soap dish with vinegar once a month and run a regular cycle with an empty dishwasher. If you're having problems with dishes not getting clean or dishwasher soap build up on the floor of your dishwasher do the above now. You may need to run the empty dishwasher with vinegar a few times to clean the drain lines; running empty once a week with vinegar is not too often.

Dishwasher Sounds that Could Indicate a Problem - YouTube

? 2:22
https://www.youtube.com/watch?v=bEBECtCoLTI
Jun 17, 2010 - Uploaded by GE Appliances
Certain sounds may indicate a problem with dishwasher loading, water fill, or an interrupted cycle. Find more ... Does it run whileopen?

5 Common Dishwasher Problems - APWagner Appliance ...

https://apwagner.wordpress.com/2008/.../5-common-dishwasher-proble...

May 20, 2008 - Running the dishwasher regularly may help prevent any seals from ...Question 2: Why aren't my dishes dry when the dishwasher finishes?

START/RESET status indicator light flashing

You have pressed the indicator light flashing START/RESET pad while the START/RESET dishwasher is running. This will cancel the cycle. The light will stop flashing after the dishwasher drains (about 90 seconds).

• Press the pad once to start the dishwasher. Press the pad a second time when the dishwasher is running only if you wish to cancel the cycle.

Power to the dishwasher was turned off while a cycle was running and power has just been restored to the dishwasher. The blinking lights indicate that the dishwasher is draining the potential water inside.

• The light will stop flashing after the dishwasher drains. A new cycle will start automatically.

Good luck

check the pump

I have been told to replace the timer which I am looking to do the same to my machine!

There is a recall on the control board of many of these models, butyour problem is likely not related. It sounds like a plugged drain system or a possible bad drain pump. That's why you are hearing the pump running constantly. I have written a guide to help. It is here. Thanks!

if the water line not blocked or pinched... then I would your fill valve.. it may not open all the way...before replaceing the water valve...check that the water is come into the dishwasher but maybe going out the drain..If the drain hose is too low water will run out before the dishwasher can run a cycle... to check it it must raise above the bottom of the sink ... this keeps water from running out and sink water from going into the dishwasher... let me know if it helps

most likely a new controller switch only...