Monterey boats how do you lower the tower?

Are you interesting in kayaking in Monterey? The gentle, cool waters of the bay make it the ideal place for newcomers or those looking to develop their experiences. You can either rent a kayak to go on your own or join a guided tour. If this is your first time, I suggest that you go with a guide or take a short practice session to learn a few methods before you set out on your own.
To know about kayaking you may check this link
Best Rated Kayaks in 2018 Tested Reviewed by Expert Anglers

ISI is a quality standard certificate in India allotted by Indian Standards Institute.This mark certifies that the product or services comply with the standards specified by Indian Government and and is developed as per the standards of Bureau of Indian Standards (BIS). Most of the electrical appliances and kitchen accessories are required to have ISI registration certificate.

https://www.gsbtaxation.com/in/isi-registration-in-bangalore/

check engine oil seals , or you make a engine service oil change recently and squirm out the engine , also check the oil filter is tight , Maybe water comes from outside when navigating

I know there are at least two. The first being under the dash to the left. Second being in engine bay above the driver side tire.

BIll

Check the electrical connections, bulb and switch.

A wakeboard tower allows your boat to have more hang time, it can be used for extra space to put wakeboard equipment (ie. racks, speakers), and it can be served for support when walking around the boat.

2004 mercury monterey liftgate latch will not release.

is it stainless-not familiar with brand-but may well be corroded-try spraying with crc or similar-may take a few doses if corroding in shaft-get rough if needed-remove if possible so you can spray from both directions

Yes, I was able to get it fixed.
The spray tower actually fits in the rack (I had thought it fit in the top of the lower spray arm - wrong!)

If you were to look at the spray tower itself, it has 2 little clip like plastic protrusions that with a little twist will clip onto the lower rack!

Push the lower rack in and you can see where the center would be, (right over the middle of the lower spray arm ).

Now pull out the rack and take the spray tower and slip it under the rack up thru the bottom in the position you noted was the center (from above).

Now with the spray tower in place, slide the rack back inside the dishwsher and you will see that the tower will be sitting directly over the top of the exact middle of the lower spray arm.

Voila!