Factory reset Behringer FBQ2496

There is no Service Manual for it.

https://www.google.com/search?q=Behringer+F1320D+service+manual

and no wiring schematic.

https://www.google.com/search?q=behringer+f1320d+wiring+schematic+diagram

Contact Behringer Support direct


..

Question edited for clarity.
Question moved from Cars and Trucks category.

In the link

Behringer Xenyx 2442 fx Mixer - FREE Service Manual

https://www.synthxl.com > BEHRINGER
Download Service & Owner's Manual for Behringer Xenyx 2442 fx Mixer ' SynthXL - FREE Service & Owner's manual.

https://www.google.com/search?q=behringer+xenyx+x2442usb+service+manual

..

Question Edited to add make and (what it is). Please always include as it helps us to help you better.

Direct to the factory.

https://www.behringer.com/service.html

..

Hi, the power light should not "blink" at any point. It should always be either on or off when either powered on or off. Sounds as though the internal toroidal transformer has gone faulty (common issue) and requires replacemnet by a professional.

Directly from the manual:
Press [Soft A] + [Soft B] + [Flash 1] simultaniously
Scroll the wheel to 'Erase all?'
Say yes.

I would check it with a different instrument cable AND bass guitar. If you end up with the same results, it's a thermal issue with the amp and will require factory authorized repair. The amp heats up and the intermittent component starts failing....more heat, more failure. It's not an easy fix and your Behringer repair shop will have their work cut out for them with this repair.

I have one, and IT WORKS for me!

As the manual suggests, the 1st step is to RESET your pedal board. I know, you 'll have to erase 20 custom presets of yours but hey, they're already lost anyway!... So just reset the on board chip by pressing the TAP and STORE buttons together for 5 seconds while you power ON the X V-amp. That's it! Now the board sounds good as new!

http://guitar-dreamer.blogspot.com.br/2012/11/behringer-x-v-amp-easy-fix.html

Get an "insert snake" which splits each of two TRS plugs into TWO TS plugs.
Plug the TRS ends into the MAIN INSERT jacks and each of the "TIP" plugs at the other end into inpout jacks of the destroyer. Plug the "RING" plugs into the output jacks of the destroyer. You will need a snake with at least two sets of splits. I use a Behringer PROCOM compressor. For those the TRS plugs go into the channel insert jacks and the tips and ring plugs go to the in and out of each channel of the compressor respectively.

Check the 5 volts to the FX unit, If the voltage is low, the FX processor will keep reseting generating clicks, In a different product, the 5 volt filter cap was degraded and voltage dipped down to 4.5 volts causing resets.

Di you mean this one? -> http://www.behringer.com/EN/downloads/pdf/PMP1000_P0566_M_EN.pdf