Constant clicking from freezer fan that won't start

Buy a used fridge on ebay, they are very cheap.

It sounds like the compressor start relay is bad.

It's probally the fan motor. Sometimes adding a drop or oil to the shaft will quiet down a noisy fan.

There are several fans on your unit one on the top with the compressors, one inside the freezer, and one at the bottom. If you open the freezer and the noise gets louder or stops then you know it is the evaperater fan. Sometimes the bearings start to go and they make louder noise. Also check on the back wall for frost you could have a frosting problem and the fan blade is hitting on the ice

if the fan blade is contacting anthing under there and stops it will shut down the compressor and wont work

Hi!
Self-defrosting refrigerators use a circulating fan to move the air through the freezer and refrigerator compartments. This fan runs whenever the unit is cooling. The fan is located in the freezer.
Over time, the fan may become noisy--usually making a chirping or squealing sound, though it may make a loud groaning noise instead.

To find out if the fan is causing the noise, just open the freezer door and push any fan/light switches. If the noise is louder when the door is open, the evaporator fan motor is the cause which can't be lubricated or repair instead required to be replaced.

Please do rate this solution as FixYa and revert for further assistance.

Thanks
Rylee

This clicking noise is a bad relay.
Get it serviced before you run in to a real problem

Clicking was a relay. Replaced relatively inexpensive relay and now working fine.

Sounds like a problem with the compressor.  Get a service tech in.

it sounds like a bad: 

• ·       start switch (on the side of the compressor) or
  
• ·        compressor itself
  

the start switch clicks  off usually when the compressor is pulling too many amps or the compressor is overheating. if the compressor is not even running then its probably not overheating.
so either the compressor is pulling too many amps (bad compressor) or the start switch is bad and cannot handle the amps required to start the compressor.