LG dishwasher will not turn on - LG 24 in. LDF 7811 Built-in Dishwasher

AE & E1 ERROR CODE - DISH WASHER

LG Electronics https://www.lg.com > support > help-library > ae-e1-er...
Nov 8, 2023 - An AE or E1 error code means you have a leak inside your dishwasher activating the float switch. Before you can start using your dishwasher ...

Missing: LD2050SH ‎' Show results with: LD2050SH

Help library: AE & E1 error code - Dishwasher

LG Electronics https://www.lg.com > Home > Support > Troubleshoot
Dec 13, 2023 - The AE or E1 error code indicates a possible leak from the unit. ... Then run an empty cycle with nothing in it to clean out the dishwasher. If ...

Missing: intello ‎ LD2050SH

LG Dishwasher - Error Code List ' LG USA Support

LG Electronics https://www.lg.com > support > help-library > lg-dish...
Jun 20, 2023 - If overfilling occurs, the flow switch will trigger an E1 error code and your dishwasher will turn off to prevent outside leakage.

ie means water
le is pump bad

HOW OLD IS YOUR DISHWASHER?

On an LG LD-14AW1, three is a float sensor on the left hand side of the dishwasher, behing the water outlet port.
It is the sensor that tells the dishwasher to stop filling just before the wash or rinse cycle begins.
A service call is needed or post back here is you want help replacing it.

If you are still having problems with your LG dishwasher, turn off the hot water supply to the dishwasher and remove the hot water inlet pipe (remove the lower, front panel (toe kick plate) )
Check the screen/filter at the water inlet on the dishwasher.
Reconnect the pipe and turn the hot water supply back on.
Test out and enjoy!

Well done! Can you confirm that you own an LG dishwasher?
Thanks!

I have had that where the filters are dirty,

check and clean filters at base of dishwasher.

Chris

lg durban

031-7165444

The problem with the dishwasher acting haunted is probably the main controller card. If you don;t have an extended waranty, know that LG will cover the parts for free through 24 months but after 12 months, the labor will be charged.

your model probably has a coating of a black tar-like substance on the inside of the inner door, which, by design, reduces noise. However, LG failed to notice the corrosive properties of the black tar-like layer. Your wiring harness is probably corroded by the soundproofing, and you will need a new inner door, wiring harness, and circuit board. LG extended my parts warranty because they know it's their fault, Call them at 1-800-243-0000. They will recommend an LG warranty repair certified technician in your area to come out and confirm this. They probably won't extend the warranty until after the tech checks out ur unit. However, labor will be your responsibility.

If you have confirmed power to dishwasher, you are pobably looking at a control board. I have only run into this one time on a LDS5811 so far. Parts on LG dishwashers have a two year warranty. You have to dissassemble the door to replace the part.