Hbh pv 705 not connect other mobile

this for sony ericson, not for nokia

How to restart my hendsfree? pls answer me, i can connect it with no one

Hullo Tillgustaf
I understand you need an A2PD compliant bluetooth adaptor. I’ve just installed one on my PC at work, asked Windows to look for updated drivers on the internet and it has installed correctly.
You can get an A2PD adaptor from Amazon for £1.50 here
Best wishes,
Phil

Read the manual of the HBH-IV835.
Page 15 "Prepare the headset".
This solved the problem!

The manual is at
http://www.sonyericsson.com/cws/download/1/105/377/1192973590/HBH-PV702__UG_R1a_Multilingual1.pdf

0000 is the passcode

just turn on bluetooth in ur mobile and then turn on ur bluetooth headset by holding the power button for atleast 5 sec and if blinking green light show up it means that it is turned on,if it shows blinking red and green then it is ready to get paired with ur mobile phone so u can straight away connect the bluetooth by selecting handsfree and new device and in the list of divices select hbh608 and get it paired.if it shows a blinking green then hold the volume increase and decrease button at the same time for 5 sec and then the light turns blinking red and green and then u can go to handsfree and new device and select HBH608....its easy try doing that...it workss....

switch on your bluetooth and press the push button until the led stops blinking.
now you can go to the bluetooth application on your mobile phone and search the HBH-PV700 .

Press and hold down the headset volume key in the centre. Hold it for about 5 sec. The led will now flash on/off in red. This is the pairing mode. Set your mobile phone to blue tooth discovery mode,until it finds the headset, key in the pass key, 0000. It should now work. You may need to set the phone to select the headset as an automatic connection so it connects whenever it is on and in range.

You must operate your bluetooth headset HBH-PV700 in discovery mode in order for your mobile to discover the headset and then pair the two devices. To activate the discovery mode of your headset, while it is switched OFF press the switch on button and leave it pressed for approximately 10 seconds, then search for it with your mobile and pair the devices. most of the times the code needed for pairing is 0000 (zeros)