How do i remove postcodes from sat nav - Navman Mio M400 Car GPS Receiver

Contact me at: [email protected]

This Sat Nav system is a total let down! I could not use it to navigate in Bournemouth city centre, it kept on telling me to turn in to one way streets going opposite traffic and could not even take me to Luton airport (so basic!) neither LU2 9LY nor LU2 9QT postcodes were recognised by system giving error: NO MATCHING POSTCODES
Even after full software update the device was clueless what to do with many basic post codes. I may as well bin this and buy a well-known brand instead!!

some models do But not all. So if you see the option to enter postcode as a solo entry then yours will

Please rate my help++++Thanks fror using FIXYA

You need to update your Operating softvare. Go to a service or contact me.

you have go to main dealers to reset it

Hi there,

I hope everybody visiting this webpage will find this answer useful.

First of all, ignore the antenna connector recommended within the RAC Sat Nav 200 manual, it's wrong.

What you need is the :

GPS Antenna 1M Length MMCX with a
180 degrees straight connector.

Make sure it's a MMCX straight connector.

Plug in the antenna and within half a minute of typing your postcode destination into the Sat Nav the reception will have been picked up.

Hope this saves everybody a lot of hassle.

David Coggon - Author of Children's Book ` Jack's Crayons '
http://www.ahstockwell.co.uk

corrpted data reinstall

do you have a sd card? are you unlocking to much for the unit to hold memory wise?

Have you put the space in? The on-screen keyboard makes it a real pain but it can't resolve the postcode without it. Jeremy

hi mate im sure i have the same system and it does not have postcode search on it just road names