Cant open mens link bracelet that is on wrist

This person wasn't asking for advice about buying a rubber wrist strap for a diving watch, but rather was asking about where to get an extra link for the watches stainless steel bracelet1

bring it to the watch service center. then ask to put back the hands on its proper position, there's nothing to worry about it just loose. i hope i had been helped you.

Have a look at the links nearest the clasp.
These should have markings on to say which are removable. An arrow or some other indication.
Not sure if this watch has press pins that go through the whole bracelet or flip up catches on each band.

---

Please dont forget to vote this answer was helpful.

Many thanks

------

Hello

I would advice that you take your wrist watch to a watch store or a jewelry store so you would be able to get the perfect and compartible bracelet for your watch.

THANK YOU

Wrap the watch band around your wrist to determine how many links need to be removed for the watch to fit properly.

2 Place the watch face-down on a flat surface.

3 Look on the back of the watch band. You will find an arrow that indicates which direction you should push the pins to remove the links.

Find the point at which the extra links need to be removed for your watch to fit your wrist. Using a 1 mm flathead screwdriver (or the edge of one side of a pair of tweezers), push the pins in the direction indicated by the arrows.

Finish removing the pins with your pliers.

Keep the extra links in case you ever need extra room on your watch band.

For further assistance, check out the link:
http://www.pulsarwatches.com/home2.asp#FAQ

mcdevito75 here, Many watches built today are not comming out with replacement Bands (straps, Bracelets) from the factory, the cost of makeing and keeping extra bands on hand is too high, they should at least have a few extra links to replace worn ones. Chances are your warantee is over on the watch and in that case, you"ll have to find another band, Bracelet on your own. Best Bet, visit a small watch repair shop in your area for another bracelet, band, Strap.

mcdevito75 here, Best bet, look for a small watch repair shop in your area to help fit your watch and to save on the cost.

Yes - you have to use punch and mallet. Punch must go in where the screws came out and as the result you will have bracelet screw ends coming out from the other side of bracelet.
Rate, plz.

I just recieved a Moldavo Men's Junior Sport (Model # 0605105 with certificate of authenticity) as an award -- but the instructions didn't bother explaining how to put the watch on!

For any hidden clasp band, see this web page (excerpt below):
http://www.worldofwatches.com/cust/sizingwatch.asp?d=0

Refer to the "Hidden Clasp" diagram and follow the instructions under the diagram:

To open this clasp, reach under the bracelet band and lift upwards. The band extends to allow for easy removal.