NORDIC TRACK 2050C BELT SLIPPING - NordicTrack Exercise & Fitness

SOURCE: Nordic Track Treadmill Viewpoint 2800 : The belt

It needs to be adjusted as shown in your owners manual.
There are two allen screws located at the back end of the treadmill. That's where you adjust it. 3 - 4 inches of slack midpoint is just right

SOURCE: I have a Nordic Track treadmill C1800. When first

You have 1,2 or maybe 3 problems. 1st is you need to remove the cover over the motor. The belt that the motor turns may be slipping. You need to loosen the bolt that keeps the tension on the drive belt. Push down to tighten manually and then tighten bolt. While your in there you should check the drive belt for wear. If you have used the treadmill a lot it may need replacement. $20 from readmilldocter.com The walking belt if badly worn can be replaced for like $99 but probably is fine. put all back together and tighten tension. Should be able to lift walking belt 3 to 4 inches from center sides. Any less and its too tight. Its probably better to just replace the drive belt anyway. This should work. Do not over tighten ever. This is the cause of most problems.

SOURCE: Belt slipping on Nordic Track c1900

My belt is slipping I tighten both alan head screws to the max roughly 7 turns and still have the broblem

SOURCE: Have a nordic track exp 1000x treadmill and the

my nordictrack exp1000x doesn't elevate anymore, what can be the problem and how can i fix it?

SOURCE: our belt is slipping on our nordic track c1900

I have the same unit. First, remove the hood. Then, the motor has an adjustment screw on the belt side of the motor. Loosen the nut a little, adjust the motor up or down to make the belt as tight as you can by hand, then re-tighten the nut. This always fixes mine.