The light is on, the timer is working but the washing cycle does't start
SOURCE: dishwasher won't start rinse cycle
if the water is switching off at the correct level to initiate the wash cycle and assuming that the water is not being pumped out continuously after that, i would say you have an electronic control problem. there should not be any changes taking place on the display when opening the door
SOURCE: Electronic Timer sticks on Wash Cycle
hi
Because the timer controls many operations, a faulty timer can cause many problems. The timer is a complex component, so you shouldn't attempt a do-it-yourself repair. Test the timer with a VOM set to the RX1 scale. To gain access to the timer, remove the front control panel. The timer is directly behind the main timer control knob. Disconnect one of the timer's terminal wires and clip one probe of the VOM to each terminal. If the meter reads zero, the timer is working. If the meter reads higher than zero, the timer is faulty and should be replaced.
If possible, use the same procedure to test the selector and cycle switches. The wiring hookup, however, may be too complicated to figure out on either of these switches. If you aren't sure you can deal with these switches, call a professional service person. Replace a faulty timer -- or a faulty control switch -- with a new one made for the dishwasher.
The timer is connected to several wires that supply power to operate the various functions of the dishwasher. To replace the timer, have a helper hold the new timer next to the old one. Connect the wires of the new timer one by one, removing the old wire and connecting the new, to make sure you connect the wires correctly. The wires may be friction-fit on the terminals. If they are, use long-nosed pliers to remove the wires. Don't pull up on the wires, or you may break the connection between the wires and the clips.
After connecting the wires, set the new timer in position, secure it the way the old one was secured, and replace the control panel and knobs.
SOURCE: dishwasher starts but never seems to come out of wash cycle
Hi,
Check to see if the unit is heating. Open the door mid cycle. If the unit doesn't heat then the unit cannot advance to the next step in the programme. it is basically waiting to reach temperature which it won't if the heating element or thermostat has blown. Hope this helps.
SOURCE: Bosch shu4006uc dishwasher timer problem
REPLACE YOUR MODULE. IM A OLD BOSCH TECH. POST 4 THUMBS FOR THE INFO THANKS
SOURCE: Bosch dishwasher timer sticking
I have been told to replace the timer which I am looking to do the same to my machine!
119 views
Usually answered in minutes!
×