Error fuser temp

what model #############################

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

model ###################################

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

good day sir.this a fuser temp error. These units are notorious for having fuser temp errors when there is dirty or unstable power, especially if the customer is running off a generator. the best way to fix this is to replace or rebuild the fuser assembly. goodluck!

Disassemble fuser unit and inspect thermistor and thermostat for dirt or damges, and heater lamp for damages.

Good luck.

You need to have the Fuser replaced

SISODIYA COMPUTERS "I AM SOLVE THE PROBLEM FUSER TEMP ERROR "
BUTTON FAST PRESS STEP BY STEP
LET'S START
PREES- MENU BUTTON
* BUTTON(THIS IS STAR BUTTON)
# BUTTON
1 BUTTON
OK BUTTON
STOP BUTTON
MENU BUTTON
# BUTTON
^ BUTTON(THIS UP ARROW BUTTON)
OK BUTTON
YOU LAST BUTTON PRESS OK AND POWER "OFF" AND WAIT UNTIL 15 MINUTE AND PRINTER START PROMBLEM IS SOLVE FUSER TEMP

fuser Temp printer error problem.please give me the solution.

It is giving me an error message of "printer error,fuser temp"

Hello,


The error code is related to the fuser area.

Likely to be a low fuser temp issue.


Need to verify good or bad heat lamps.

1) Check each lamp in fuser.

(lamp is good if you get continuity)
(lamp is bad if open)

2) Check the thermostat. (thermal control device)
(triggers if unit gets too hot)

3) Also check thermistor (monitors temp of fuser)
(2) total (middle and rear)

If heat lamp is good:

Your best bet is to change all three items. (Temp fix)

Fuser thermostat - thermal control device
Fuser thermistor (middle front) - thermal control device
Fuser thermistor (rear) - thermal control device

These items wear out. Change at the same time.

Fuser needs to be rebuilt or replaced.
(Check for wear and tear)


Inexpensive repair for the temp fix.

The whole Fuser cost can brake the bank.


I buy parts from precisionroller .com (you can preview the parts)



Franklin
baselinerepair .com

That is a fuser erron code. Abnormal temperature. You will need to replace the fuser. Sometimes I have sen a buildup of toner on the thermistor. If you can get to it. You can try to clean the toner off. Be careful. Very hot.

I’m happy to help further over the phone at https://www.6ya.com/expert/jayw_0e86fb055a7b73de