The bulb is not turning on and I have a solid red light under temp and lamp categories.
SOURCE: Both Temp and Lamp lights blink red
All you should need to do is go to the menu on the
projector, and find the Filter Timer. Hit the right arrow to select the filter
time, and then hold the rest button on the projector until you are prompted to
confirm the reset. Hit menu to confirm and it should now reset the filter
timer. Now cut the projector off and back on and the lights should stop
blinking. I hope this helps.
SOURCE: ceiling mounted PJ551 - lamp light red, power light blinks red
I have PJ 550 exact SAME PROBLEM replaced bulb NOTHING
SOURCE: I turn on my Viewsonic
sounds like a bad bulb
projectors get a resistance reading from the bulb and if it doesnt get right value it will give you the double red lights
only other thing it could be is if the fans in projector are not turning on
call viewsonic and tell them issue and make them resolve issue
or
if unit is only 2 weeks old bring it back to store and get replacement or call viewsonic and get them to send you replacement unit - it is too new to mess with it yourself and take chance on voiding warranty
Warning Indicator
? When the "LAMP" indicator lights solid red, the projector
will automatically shut itself down.
? When the "TEMP" indicator lights solid red for about 60
seconds, it indicates the projector has been overheated. The
projector will automatically shut itself down.
Under normal conditions, the projector can be switched on
again after it has cooled down. If the problem persists, you
should contact your local dealer or our service center.
? When the "TEMP" indicator lights solid red, it indicates the
fan failed. Please contact your local dealer or our service
center.
146 views
Usually answered in minutes!
×