Blue message appears in the upper left corner. SH770 P7002Q. Qdi. QD17EL07 What to do to remove it?
SOURCE: Mag Innovision LT776s 17 in. Flat Panel LCD
I have the same problem except it usually happens after Ive left my computer idle for a while... i.e . Overnight, I usually turn off the monitor and I hit the button after I come back to turn it on. I get the same flashing light for several minutes. This has been a problem for several months, but only recenly have i gotten the same error message you mentioned. Each time ive booted the computer up cold or restarted it has worked fine but this time it took longer along with displaying the message: Top Left to Right: SH770 P001 Bottom Left to Right: AU M170EN05 Anyone else who can clear this up?
SOURCE: Unwanted Message
Generic Answer:
With most models of these monitors, hold in the menu key for more than 10 seconds.
If the above does not work, call the manufacture tech support. The monitor may need service.
Jerry G.
SOURCE: Samsung syncmaster 931a... connected to computer
Hi, its unlikely to be the cable. Most likely cause of this is a faulty inverter board. If you are lucky it will only be 1 or 2 blown capacitors which are easily identifiable and replaceable once you have got inside it. it could however, be almost any of the components on the inverter board or even a failed backlight but this will require further testing and a knowledge of LCD monitor workings.
SOURCE: a lot of dead pixels red and blue appeared in
Not much that can be done about this damage to the monitor, probably in shipping.
84 views
Usually answered in minutes!
×