Question about Audio Players & Recorders

1 Answer

Onkyo htrc230 No sound on my Onkyo HT-RC230. The HDMI card has a large chip next to the HDMI output that runs extremely hot. Where can I get this repaired or replaced reasonably. Onkyo sent me to a service center who wants close to $300.00 to fix it. I can replace the board myself if I can get the part. Thanks, Ken

Posted by Anonymous on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

  • Expert
  • 100 Answers

Your best bet is the service center unfortunately, getting parts for devices like that are very hard for independent small shops, we usually either have to send them to the manufacturer or their service center anyway, or tell the customer its not repairable. If you can find a board to replace it with chances are that board might not be much better because its used and salvaged out of another unit. Its just how it is with consumer electronics these days, you can't always fix them.

Posted on Jan 02, 2018

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 81 Answers

SOURCE: Amp Protection Mode

no, your output transistors maybe 2 of them are gone or the small power supply that feeds the other circuitry has become defective.

Posted on Dec 15, 2006

  • 1 Answer

SOURCE: Onkyo 605 HDMI Sound

Change the setup in the Hardware control/HDMI/ HDMI Audio...

Posted on Jan 26, 2008

  • 4234 Answers

SOURCE: hdmi out [of amp damaged needs replacing onkyo tx sr605

You will need to contact Onkyo directly and request the board from the parts department. I was not able to locate a part number for this as we are usually requested to perform component level repairs for these units.

Dan

Posted on Nov 04, 2009

  • 1 Answer

SOURCE: onkyo ht-r960

I had the same problem at 1 year after purchase. I was upset. In addition to looking here, I also emailed the company. They took a month to get back to me, but their solution worked perfectly.

"Try resetting the unit by pressing VCR/DVR and the standby/on button at
the same time on the front of the unit while it is turned on. The unit
will display CLEAR and shut down. All settings will be erased. "

All my components connect without any problem now. Hope this helps.

Doug

Posted on Jan 17, 2011

michael_obar
  • 1 Answer

SOURCE: Onkyo remote code for Insignia Blu-Ray?

Insignia may not have a code for your remote, BUT your Onkyo remote can learn the button functions directly from your Insignia remote. It is much more tedious because you have to "teach" each button one at a time. However, it is actually quite easy.

Posted on Feb 16, 2013

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Sound from Onkyo CD player well and fine. Then connected the Samsung DVD HT-Z310 to Video3 (L/R audio in, V-in from L/R Audio out and V-out of Samsung) but no sound or nor video on TV? Tried to fix it...


What am I missing here?

There are a lot of models mentioned in this post. What are WE discussing?

* A Samsung HT-Z310 is a Home Theater System.

* An Onkyo TX-DS777 is higher-end AV Receiver that DOES have a Video 3 input which accepts composite video and analog audio.

* An Onkyo CD player is irrelevant to the TV sound in any scenario.

* Unnamed TV.

I don't see any path in your narrative that would carry audio TO the TV. Is there an unmentioned HDMI cable in here somewhere? I see no other audio outputs on the HTZ.

Are you running the HT-Z310 through an Onkyo receiver to somewhere (?) else?

Register and download the manual for free at retrevo.com

http://www.retrevo.com/support/Samsung-HT-Z310-Home-Theater-Systems-manual/id/23122dj393/t/2/

The fewer hops and inteconnects a given signal experiences between its source and your senses, the better. I always run the BEST video from any source to the TV first; the best Audio to the BEST audio electronics. If that helps.

Apr 03, 2011 | Onkyo TX-DS777

1 Answer

I have purchase an onkyo HT-RC230 receiver. I want to connect a Directv R16-500 DVR & RCA L32W22 TV. Directv satelite service is currently connected to the DVR and DVR is connected composit S ports of ...


This is a rather uncomplicated satellite receiver, and basically only has a left/right audio out.
You can hook these into any of the stereo type inputs on the HT-RC230.
This receiver is also the "wal-mart" brand of Onkyo (not their best stuff) - so I suggest you take the L/R audio out on the DVR and put it into ANY available (cd/tape/dvd) stereo input on the receiver.
You aren't going to get better sound out of any specific input.

Feb 21, 2011 | Onkyo Audio Players & Recorders

1 Answer

The HDMI is not outputting to my display. I have 3 inputs and none of them work. However they did work for about 2 weeks with no problem. I can take the input directly to the display and they work...


Measure all hdmi inputs and output HPD Voltage by a needle probe.
Steps:
(1)unplug the amp.
(2)open the cover.
(3)connect a blu ray player to hdmi input & a mon to output, otherwise no 5V.
(4)negative probe connected to the large heat sink with large power transistors mounted by a crocodile clip.
(5)postive probe to right hand side last pin called hot plug detect, HPD.
(6)If it has 5V, hdmi board is OK. Check HDMI cables(7)If no 5V, check power to this board. Go to you tube:How to fix an Onkyo receiver - TX-SR606 . All large capacitors next to SMPS IC are replaced.
(8) If not OK, replace Q 8595-Q8597.
(9)If not OK, replace Q8501,sil9135.(Onkyo won't help you to replace this HDMI decoding Chip. A HDMI board replacement instead, the company policy.)

Oct 02, 2017 | Onkyo TX-SR605 Receiver

1 Answer

I have a n onkyo av reciever ht-r560 only the front 3 speakers go on when im using it i know the rest work and are plugged in correctly because the volume tester outputs sound through it. Is there an on...


Your sound might not be working because the HDMI and optical audio inputs might not be working.

I made the mistake of buying the Onkyo HT-560 and in less than two years all of the HDMI video inputs started intermittently breaking. Sometimes when you selected the channel both the image and the sound would not come though.

Also the rear speakers stopped working from time to time and I have to run the setup again to get them to turn back on.

I am not sure that Onkyo was ready to introduce this technology, it has been a nightmare and my stereo is going to cost almost as much as I bought it for to fix it.

Oh and there customer service was no help, they just told to bring it to an "authorized service center for repair". They had also had no idea where there was one in my city it took them a day to get back to me.

The Onkyo HT-S5100 looks almost identical to the HT-560 not sure if they are different in anyway.

Stay away from Onkyo in the future! I know I will.

Sep 02, 2010 | Onkyo HTR500 Receiver

3 Answers

I have a Onkyo TX-SR806 HDMI output does not work anymore. Tried switching HDMI cables. My component video output works.


Sounds like you may have a bad HDMI card my friend. I had an issue with my HDMI card that was causing blue dots to appear on the dark parts of the screen, when outputting 1080p over HDMI. This is a rather common issue, so it wouldn't surprise me if your HDMI board needs replacement - especially if you've ever experienced the infamous blue dot issue.

Jan 22, 2010 | Onkyo TX-SR806 Receiver

1 Answer

Xbox 360


There are a couple of options you can use.

Are your DVD and cable actually going to the Onkyo first and then to the TV? I am assuming it is, if you listen to the Onkyo when watching a DVD or cable.

The Onkyo receiver you have has 2 hdmi inputs and 1 hdmi output.

Does your Xbox360 have an hdmi output and that is what you want to connect to the Onkyo? Some do and some don't.

If your Xbox has a hdmi output and you are already using the 2 hdmi inputs on the Onkyo, you can not connect the Xbox using the hdmi, you have no more hdmi to connect to, so you must go thru one of the other inputs of the Onkyo.

The hdmi has the video and audio together, the other video options do not. you would need to run seperate audio cables as well.
Your Xbox should have a composite video (yellow RCA jack) output or a component video (1 red, 1 blue, 1 green RCA jack) output.

When you connect the Xbox thru, lets say the composite video of the Onkyo , you will also need to connect the audio from the Xbox to the Onkyo on the same input. It should be right next to the yellow RCA jack or right under it. They are 2 RCA jacks, one red and one white.

You will then need to connect the composite output of the Onkyo to the composite input of the TV.

When connecting like this, you will also need to select the composite input on your TV with your remote for your TV. Your TV should have an input button that lets you go thru all the different inputs to it.

you can also use the component video from the Xbox if it has that. But you must also run the audio to the Onkyo as well to the corresponding audio inputs of the component video input on the Onkyo.

This may sound a little confusing, but remember that the hdmi has the audio and video in one cable, the other video options do not, so you must run additional cables for the audio to the Onkyo from the Xbox.

Also remember whichever video you use from the Xbox to the Onkyo, you must also run that same video from the Onkyo to the TV and then switch the TV over to that input when you want to watch the Xbox on the TV




Jun 21, 2008 | Onkyo TX-SR605 Receiver

1 Answer

Onkyo 605 HDMI Sound


Change the setup in the Hardware control/HDMI/ HDMI Audio...

Jan 17, 2008 | Onkyo TX-SR605 Receiver

2 Answers

Connecting a Dish 622 Receiver to the HTR500 and a Sony HDTV TV


I haven't researched to actual manuals for your equipment, but I'm guessing that the optical may be disabled when the HDMI is used. You could try using the component video outputs to the TV and then the optical to the Onkyo.

Jan 02, 2008 | Onkyo HTR500 Receiver

1 Answer

Onkyo HT-SR750


Check out Onkyo's website: The HT-SR 800 description says "a separate audio connection is necessary" Maybe it is true for the --750 too.

Jan 01, 2008 | Onkyo TX-SR605 Receiver

Not finding what you are looking for?
Audio Players & Recorders Logo

Related Topics:

148 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audio Players & Recorders Experts

 Grubhead
Grubhead

Level 3 Expert

5699 Answers

The Knight
The Knight

Level 3 Expert

76140 Answers

Marvin
Marvin

Level 3 Expert

85206 Answers

Are you an Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...