Making beep sound lamp - Samsung SP50L6HX 50" DLP HDTV

If your Kodak 600H projector is beeping when you turn on the lamp but stops when you turn off the lamp and leave the fan and power on, it could indicate an issue with the lamp or its connection. Here are a few possible explanations:
1. Lamp Replacement Needed: The beeping sound could be an indication that the lamp needs to be replaced. Projector lamps have a limited lifespan, and when they reach the end of their life, they may produce warning signals, such as beeping, to alert the user.
2. Lamp Connection Issue: Check the lamp's connection to ensure it is properly seated and securely connected. If the lamp is not properly connected, it may trigger an error and cause the beeping sound. Try removing the lamp and reattaching it, making sure it is correctly aligned and connected.
3. Lamp Compatibility: Ensure that you are using a compatible lamp for your Kodak 600H projector. Using an incompatible or non-genuine lamp may cause compatibility issues, triggering the beeping sound.
If none of the above steps resolve the issue, it is recommended to consult the user manual for troubleshooting instructions specific to your projector model. Additionally, contacting Kodak customer support or reaching out to a qualified technician for further assistance may be beneficial.

Did you check the ballast for the lamp? It provides the high voltage/energy to excite the lamp (no filament) into operation. If it does not work properly neither will the bulb.

Great set - I have the 5685.

1,Check the fans ,whether the fan is running,when you turn on the projector
2,if the fans run, then ,check the lamp or lamp ballast

turn on the projector ,at the same time ,if you can hear a continuous beep beep

sound (the ballast igniting the lamp)
means the lamp may be fault,and other parts is working well

Sounds like a door switch is not making proper contact--or has been damaged. Check the lamp door switch and see if it is properly seated and the pin on the door is hitting the leaf of the switch.

Inspect both the lamp and the color wheel that faces the lamp--unplugging simply makes the set try to reboot.

First thing to do is to remove the lamp and try to reinstall, and make sure everything is blown out and free of dust, the lamp and door has to be in the right position, to operate right. If that still don't work, then it could be a bad ballast board.

Ur lamp is dead.Replaced the lamp.

the light bulb is most likely burning out or lamp hours have set a certain hours and lamp will need to be replaced or lamp hours need to be reset.

You need to replace the Lamp

This could be a number of things. Your lamp could be bad or it needs to be reseated to the ballast. The lamp is trying to light and it will make the ballast flicker (that is the clicking sound) or your ballast is bad and it needs replaced (it will flicker and click too). Or your color wheel is broken and it will make a clicking sound when turning. If the color wheel is not spinning or broken it will not light the lamp. No lamp no picture.