Dremel 3000 stopped - Dremel Tools & Hardware - Others

If it doesn't work at low speed, even after first getting it started at high speed, there's something wrong with it.

There is a coupling between the drive motor and the chuck. You will need to take the tool apart to replace it. E-bay has these.

It will be under warranty if just bought it , if faulty it will be repaired or replaced at no cost to you .

You can change to any bit, but have to change the compression collar inside the end of the shaft. For example if the tool shaft size is 1/8" you need to use the 1/8" collar etc. Make sure you use the corresponding bit with the corresponding compression shaft size or the bit will not lock in position when you tighten the collar.

try installing a new set of brushes in it i have fixed mine lots of times by doing just this !!! new brushes are sold where ever real dremel tools and bits are sold ck package back for your model number

Mine died also. It's the on off switch. Where can I get parts?

its a comon thing with a dremel to just burn out in use iv got through 3 of them all died the same way

Something amazing just happened! On my monitor screen, window popped up that said, "ASK A QUESTION - LET OUR EXPERTS SOLVE YOUR PROBLEM FOR FREE".

I couldn't resist getting expert advice for free, so I clicked on the window. I was immediately taken to a magical world where I can pay for expert advice. I opted not to pay for expert advice. The next day, I was asked if the help I received was helpful. So here I am posting this response. I haven't received any expert advice yet, but when I do....!

The Dremel 275 (and other series) have a plastic coupler and spline that connect the motor shaft to the collet shaft (where the tools attach). The plastic fatigues and disintegrates, causing the collet shaft to stop, even if the motor is still running. The fix is about $5.00 --- two parts from Dremel. The 275 case is a **** shell that opens with the removal of six T-10 Torx screws.

you should have a little wrench that came with it

and on the neck of the dremel there is a shaft stop button

push the button and manually rotate the dremel head till

it clicks then hold the button and use the wrench to loosen the bit