Eror code M2 - Konica Minolta bizhub 161f All-In-One Laser Printer

http://www.copytechnet.com/forums/konica-minolta/62595-konika-minolta-bizhub-163-error-code-m2.html

no such counter m1?

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

2006 freightliner m2 code bh 164 don't star engine I don't now why !!!

Hi,
E585
At the start of the motor CCW operation, the stack handling motor (M2)
may be driven for a specific number of rotations; however, the stack delivery
lever home position sensor (S8) does not go ON.
Cause:
The stack handling motor (M2) is faulty. The stack delivery lever home position
sensor (S8) is faulty, the connector is disconnected, or an open circuit
exits. The stack handling motor (M2) relay harness is faulty. The return
roller is faulty

First try to replace motor.

Hope that helps!

check the cd and the hard disk.

Your graphics card having some problem ...

M2 is a maintenance code, it is usually tied to one of the machines consumable products, drum, developer, or fuser rollers. These items should be checked before attempting to reset the code.

Hope this helps.
Ed

Whenever switchon my Dc12 The mahinc ready within 5 minutes and final stage it shows the eror like "System Fault" error code 3 -380 Switch of your printer and on. How can I solve it.

#include<stdio.h>

float add(float,float);
float sub(float,float);
float product(float,float);
float divide(float,float);

void main()
{
float n1,n2;
char sym,choice;
printf("This Program is a program for calculator\n\n");
scanf("%f%c%f",&n1,&sym,&n2);
if(sym=='+')
printf("\n%f",add(n1,n2));
if(sym=='-')
printf("\n%f",sub(n1,n2));
if(sym=='*')
printf("\n%f",product(n1,n2));
if(sym=='/')
printf("%f",divide(n1,n2));
printf("\nDo you wish to continue[y/n]");
scanf("%s",&choice);
if(choice=='y'||choice=='Y')
main();
}

float add(float m1,float m2)
{
return(m1+m2);
}

float sub(float m1,float m2)
{
return(m1-m2);
}

float product(float m1,float m2)
{
return(m1*m2);
}

float divide(float m1,float m2)
{
return(m1/m2);
}