Jura Impressa S9 Steamer trips circuit breaker

clogged clean with vinegar

Ah the Subaru Impressa with S9 engine. :>D

Not quite "says it all" Bryan. So.....
Question edited to add the maker and 'what it is', a Coffee Maker.
Question moved from Cars and Trucks to Jura Impressa category. When you add a maker, you are offered the correct category, 'Impressa' gives you generic Cars and Trucks.

You have a 'Replace Now' message that no one else has!

https://www.google.com/search?q=Jura+Impressa+S9+%22replace+now%22

However, try this. Remove the Grounds Bin. Disconnect from the power. Replace the bin, reconnect power.

This is your manual

https://www.seattlecoffeegear.com/assets/user-manuals/jura/jura-impressa-c9-user-manual.pdf

Press CTRL+F, and type 'replace' and press enter. There are 16 mentions. I think it refers to the grounds bin being not fully placed. I have come across this many times, there is a small infra-red sensor or a proximity sensor.

Maybe reading the user's manual you can have a hint?
Download it from

http://www.ooo.jura.com/home_ooo_x/service_support/download_manual_jura_impressa_s9notc_english.pdf

http://www.us.jura.com/home_us_x/service_support/manual_home/manual-machines/download_manual_jura_impressa_s9otc_ul_english.pdf
check out manual on page 23

The Owner Manual for the Jura Impressa S9 One Touch identifies Error 2 as being too cold and disabled for safety, but simply instructs to "Turn the IMPRESSA off at the power switch. Contact Customer Support in your country." for all other errors.

See Online Manual: http://content.costco.com/images/Content/Misc/PDF/OwnerManual-671992.pdf

Hi, I made a video how to fix your Jura step by step, good luck... http://fixandparts.wix.com/nicknicoloudis#!jura-coffee-machine/c15gy

Hi, I made some videos how to fix your Jura step by step, good luck... http://fixandparts.wix.com/nicknicoloudis#!jura-coffee-machine/c15gy

Hi, I made a video how to fix your Jura step by step, good luck.
http://fixandparts.wix.com/nicknicoloudis#!jura-coffee-machine/c15gy

Hi.Id check the solenids and pumps. Most likely to be a pump. Their positioned under the water tank. Full disassembly of the machine panels, a must. They slide out when your there. dazza

I had a similar problem. I took off the side and rear cover, followed the hose that comes from the steam wand to the rear of hte unit. It enters a solenoid made by ACL Italy. I dismantled the solenoid unit by disconnecting the two hose ends, removing the relay, and unscrewing the plunger unit (vertical pipe). The plunger unit internals should move freely up and down like a piston in a cylinder , powered by a small spring. In my unit, this plunger was calcified and seized. I soaked it in boiling water and pressed on it gently several times and it unstuck. I put it all back together again and presto! Good luck