Need to reset the administrator password on a Konica Minolta Bizhub Di2010f

Use this function to initialize protect passcode and administrator's password.
1. Press <Mode>, <*>, <6>, <1>.
2. Press either [Initialize Protect Code] or [Initialize Admin Password].
3. Press [Yes].

Press <Mode> about two seconds until you hear the beep twice.
When you press " * ", you will hear short beeps.

How To Reset Admin Password On Konica Copier

Which password the admin or the individual passwords Default admin 12345678 or 00000000
Go to:
Admin setting- Security setting -admin password

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

1-Press "Utility/Counter button from control panel.
2-Press "Administrator settings" from Touch screen LCD menu,
3-Enter "Admin Password" which is 12345678.
4-After entering the above password, press "ENTER" or "END" button, (appeared on top right side of menu).
5-After pressing the end or enter button you will be in administrator mode.

Now, if you are asking about the Administrator password, then the password is "12345678" This is the default administrator password of Konica Minolta bizhub MFPs and Photocopiers.

For any other queries, feel free to ask any time.

how can i reset the password for my konica minolta bizhub 211 to remove the maintainance call 2 display?

I had an older Minolta a couple of years ago. I'll try adapting what worked for it to this machine. Hopefully this will work.

Press the "utility" button. Then hit "admin settings". Enter a password of 12345678. Then hit "user authentication" and put in "off". Hit panel reset from the main menu.

Again, I'm not entirely sure this will work for the 420 but its worth a shot. Good luck!

There is no procedure to restore the admin password. It is possible to reset and enter a new password, and for that you will need a technician to make the adjustments on SERVICE MODE (stop,0,C).

Network settings are accessed through the Administrator menu. Press Utility/Counter, then choice #3 should be Administator Settings. Enter your admin password and Network Settings should be choice #5.
Also, if the bizhub is already on the network, you can enter the IP address into your web browser and log in as an administrator to get to the network settings.

To recover/change the Administrator password perform the following;
1. Enter the Service mode.
2. Press STOP-0-CLEAR to enter the Enhanced security mode.
3. Enter Administrator Password setting, and enter new Password.

You can try the default admin password which is 12345678