Bosch Axxis Washer Detergent slot codes; what do they mean?

You do not state the type of stacking kit installed on your Bosch washer. The installation instructions of one of the stacking kits is found at the site Assemby Instructions Bosch Axxis Stacking Kit /WTZ11310.pdf . First remove the front concealment strip to expose the front of the mounting kit. Gently pry with a wooden tool to prevent damage. Once the it is exposed, there are two clip inserts in front of the dryer feet that must be removed. Once these are removed, you pull or slide the dryer forward to release them from the stacking kit and simply lift the dryer off of the stacking kit and the washer. The stacking kit itself is attached to the washing machine with four screws that must be removed to separate the kit from the washer top. And with that, your dryer and washer are separated!

But after separation there are two additional problems that may be bothersome to you. The first is that you now have mounting holes in the top of the washer that are exposed and the second is that the feet on your dryer may need to be replaced as parts of the feet may have been tossed during installation of the stacking kit and may need to be replaced.

The assembly instructions above show only the basic stacking kit. Some kits included a slide that pulls out to allow for a handy tray but the installation or disassembly is nearly the same.

You can find the manuals at this link
http://www.bosch-home.co.uk/customer-service/download-instruction-manuals.html

It's a classical error code, you can find all the error codes together with the troubleshooter within the manual under this article:
Bosch Axxis Washer Manual

Make sure it's plugged into dryer and not the wall

Most likely manufactures web site

Hello,

Welcome to FixYa.

i'll start with the most obvious, but still quite common oversight, have you remove the shipping bolts from the rear of the washer ?

i.e.


The next thing to pay close attention to is detergent usage. Regardless of what one may have been told, "He" detergent has to be used, and even then not too much.

Look for this symbol when buying/using detergents...




These are the most common things that can (and DO ) contribute to the machine acting in the manner you've described.

If neither of these things apply to your situation, please let me know and I'll be glad to assist you further.

Thank you for choosing FixYa and Good luck.

Regards,

Macmarkus :)

yes, just make sure its on a dedicated 120volt circuit,as in just the washer on this circuit and nothing else plugged in to it

ive seen people build there own stack unit. alot of techs will tell you no but ive seen this done and there has been no issue. just make sure your platform is strong enough to handle the tumble of the dryer during normal operation

There are usually 3 compartments in the drawer, the smallest is for using fabric conditioner, the largest is where you put the powder or detergent in, the middle size one you do not put anything in, as it is where the cold water comes in for rinsing.
Plz rate my solution.
Thanks.

If you arer going to replace the washer with a Bosch Axxis model, it will simply plug into the back of the dryer (if it is electric) because normally the dryers are 220 VAC. Works A-OK.