Warmer plate replace warmer plate

Unfortunately, there is no user manual available for the Crofton TI-CM-1013 Coffee Maker with Thermo Jug. However, it is possible that the warmer plate can be switched on by pressing the "on/off" button. If this does not work, then it is likely that the warmer plate is not functioning properly and may need to be replaced.

No warmer plate llight:
Usually means bad switch. Bunn Part no. is 20316.0001. Replacement available at link below.
Bunn Home On Off Warmer Control Switch Lighted

Note differences in switch wiring in photo below between old and new style switches.


Coffee not hot:
Make sure "Vacation Switch" is in OFF position.

Unless it is an expensive brewer, get a new one. The brewer needs the bottom plate to heat in order for it to work at all. Should be imune getting wet though, but sounds like bad heating element.

If you need further help, reach me via phone at https://www.6ya.com/expert/steve_24d988f3507f7480

You don't have to have it, but it adds something to the hosting environment. It helps keep food warm longer on the plate, and it's especially helpful for things like pasta that tend to get cold quickly.

The glass plate warmer element is faulty and short circuits every time you turn it on. The 'pop' you hear is the active short circuiting to earth. It needs replacing.

If you will call customer service at 800-352-2866 with the model and date code, we will be happy to assist you with this issue.

I am experiencing the same problem with the warming plate . did you ever find a solution?

Due to UL regulations, warmer plates can't be sent out. However, you warmer plate can be repaired for a minimal charge. Please call customer service with the model and date code and we will be happy to provide you with the cost and address.

We have the same problem on a Rangemaster Toledo 110. It is not a fuse.
The 'Hot' light still comes on because that is a different (parallel) circuit.
Examination by a competent electrician has found that the soldering for the wires that power the warming metal strip under the glass is faulty. You will have to ask for a replacement part.
There may be a design flaw, so you might want to enquire about the professional all gas burner top and just use the griddle as a warming plate over the second wok burner.

Good luck.