Electric panel Not sure if it was the cold room the bike was in but plugging it in heard a noise and bang......when its plugged in goes to clock mode and double beeps when buttons are pressed it had been working fine til then....took the circuit board out and one of the small black tubes had blown literally off where could i buy a spare board for it any other way to fix it.

Carb needs cleanin..put som BG from amarine or rv store in tank..it has strongr solvents then partstore cleaner. Nevr leave gas in bike for longperiods..it gums up fuel system..always drain n run engine til it dies. Also clean electrical connects n plugs too

When you rotated to drum you caused to belt to pop off the pulley .it has a safety switch so it won't run if belt breaks . With unit unplugged remove top than control panel than front panel to access bottom to put belt back on just enough room for hands to fix inside

TV not turning on; making high-pitched sounds - Tom's ...

www.tomshardware.com > Forum > Graphics Cards

Tom's Hardware Guide
Nov 30, 2013 - 7 posts - ‎2 authors
Both of them are refusing to turn on, and make high-pitched sounds when plugged in and unplugged. More about : turning making high pitched ...Missing: ear ‎piercing

Top 136 Complaints and Reviews about Funai TV ' Page 2

www.consumeraffairs.com > Electronics > Televisions

Rating: 1.1 - ‎65 votes
We unplugged the unit and waited 15 - 20 seconds and plugged the unit back in, and it wouldn't ... He heard a loud high-pitched whining which led him to TV in my daughter's room. ... It only makes a humming sound now, no pictures at all.Missing: ear ‎piercing

HELP! what is that high pitched noise when tv is on? - TV - Audio ...

www.tomsguide.com/forum/60895-6-help-high-pitched-noise

Jan 25, 2013 - 3 posts - ‎2 authors
Hello, I hear this constant high pitched noise, almost like ringing, but even ... pitch

Try to unplug set and plug back after a while.

Just cause the piston looks fine dosent mean the rings are still good did you do a compression test if you don't have one buy one they are great to have with 2 stroke bikes put the cylinder head back on and cover spark plug hole with finger it should first **** a bit then should blow finger off the hole the compression should be greater than 120 psi of a 125 not sure on the 250 rule of thumb if you have less than 120 your piston or rings is pooched..

I would first check to make sure the the condenser coils are free of debri and there is not something against the fan.

Did the noise sound electrical or mechanical or a hiss. A hiss is most likely a freon leak or a compressor blown (usually not worth repairing). A mechanical sound could be something blocking a moving part like a fan. Electrical could mean about anything.

I would check the condenser grill and then plug it back up and try to tell where the noise was coming from.

Usually this is an out-of-balance condition caused by too much weight on one side of the tub, move the clothes around and try again.

check the axles for leaking boots or dry axle joints....replace if necessary...also make sure all brake caliper bolts are all installed and correctly torqued

The bang you heard was probably a capacitor. Since you are still hearing the TV attempt to power on, your power supply and it's fuse are likely fine, but if the capacitor was on the mainboard, the TV would require service unfortunatley.