Hitach will not power back on - Hitachi 60EX01B 60" Rear Projection Television

I use a spring clamp to guard


https://www.manualslib.com/manual/794733/Hitachi-C12lch.html?page=19#manual


..

It could be the main video board. Have you had any recent sudden power failures?

Check and make sure nobody accidently hit the voltage switch on the back 125v / 220v

Make sure the power wire isn't broken.

It might need a fuse

Hello.

Charge/change the batteries and then try again. If you are still having problems, then chances are, the main board is malfunctioning. If it is still under warranty, send it back where you bought it and they should replace it.

Thanks for using Fixya!

Did you make sure to put the lamp door back on? There is a safety switch that will not allow the set to turn on when the door is off. If that isn't it, then you could have a bad lamp ballast or even a bad lamp door switch. I would start there. If no luck there then you most likely have a problem on the power supply module, which could be just about anything on it. Good luck.

I have the same problem with blue haze that just spread out on model 55VS69A ,
tv is almost 2 years old. i called hitachi and they advised to call a local repair center to check the tv...they confirmed Optical Block (light engine ) replacement light engine cost $1400 and labour $400, so i called back hitachi and they said they will provide light engine and will have to pay labour!....this is not right paying out of pocket for a tv less than 2 years old....I am not sure if the issue will resurface again...more likely ....Hitachi is supposed to issue a recall or atleast like sony did to cover all cost for there defective TV's....I will NEVER buy hitach again.

Hitach SUCKS.

have the poser supply checked sounds like it went out

call tech ..suggest c-chips

hitach was manufactured japan.other europern country manufactured hitach.never know if there is other name what i know there is hitach only.

Yes, you can fix it and is not to expansive. The RGB output IC is defective, but it's not easy to replace it. Better call a tech. If you're from Montreal I can do it.