Phone on DND

1. Grab an outbound line.

2. On the LCD screen look for ">>>>", press the corresponding button.

3. Keep pressing this until you see "DND" on the screen, press the corresponding button.

If that doesn't work, you need to make sure DND is PROVIDED for this phone. Most likely if you can't turn it off, NOT PROVIDED is selected.

Hello

Examine the base of the Uniden cordless phone. Locate the "DND" button on the main base of the phone.The DND button means do not disturb and it puts the phone in silent mode when pressed

Reactivate the ringer by pressing the "DND" button again. All the handsets will ring when someone calls you.

If you have not found an answer to this as yet just pick up intercom and enter 7100 at the phone. This will clear any DND. Now enter intercom 7105165. This will give a long tone and the DND/FWD lamp will flash showing Call forwarding active for VM.

Leave the handset in the cradle and press:
Feature (star) 1
Press the DND button
Press Rls

This is the feature code to add a Speed Dial # to a button, but by not entering a number, it just blanks the button. Goos Luck!

The feature should't reset itsself after you enter feature #85 (or press the DND button again). A co-worker isn't accidently turning it on are they?
You might also check if the DND button (if programmed on the set) is stuck down.

Even the older Panasonic phones had numbers stenciled in the plastic, but it's immaterial because the programming is in the cabinet. Since you can't find it, this is just a shot in the dark. Try 710#, 7100, 70#, or just try pressing the FWD button and dialing ZERO.

Carl

You get a chance for that to work next time :-)

Panasonic features are in the system, not the phone. If you have a TA series, from the phone, pick up the handset and press the FWD/DND button and dial 4#. (you may also dial 71 in place of pressing the button).

Cancel is 0# in place of 4#, but you also have CF to voice mail issues, where 1+VM EXT is all calls and 2 is BUSY/NA.

If you have a TD or TDA or TAW system, you get lucky, because the FWD/DND button works in 3 modes. For DND it's 7101 or *7101. The button will light with a solid red light and when you press it, it either flashes or goes off. The system gives you both FWD and DND settings.

Carl

There is a Do Not Disturb button on the base unit. Press it to turn the feature on and off.

Press PROGRAM + ** + User Programming Password (default is 1234)

Press 000
Press NEXT (Sp-phone button) : The date will be displayed.

To change the DATE (or you can press next again to go straight to change the TIME)
Enter the year (last 2 digits)
Press --> (FWD/DND button)
Keep pressing SELECT until the desired month is displayed
Press --> (FWD/DND button)
Enter the day
Press --> (FWD/DND button)
Keep pressing SELECT until the desired day of the week is displayed
Press STORE

To change the TIME
Press NEXT (Sp-phone button): The time will be displayed.
Enter the hour
Press --> (FWD/DND button)
Enter the minute
Press --> (FWD/DND button)
Press Select for AM or PM
Press --> (FWD/DND button)
Press Select for 12 or 24 clock hour
Press STORE (Auto Dial button)
Press END (Hold button) to exit

press dnd button twice, should work