Processing data light

in the printer properties on the pc , check for the list of items to be printed as there may be a confusion there that is not allowing the pc to send the data to the printer

it means that the printing order for the memory for the printer is full
go to control panel , go to printers and hardware , click on printer right click and it will show a section see what is printing
high light each line and delete that takes away the priority of the stack until there is nothing left to print and the printer should again print at the next selection you make
How the program works is this
there is a small memory in the printer and a large one in the pc
when you have data that is to be printed, the pc sends the data until the printer memory is full at which stage the printer starts to print. new data is sent as memory space becomes available until the document is printed
when different data is requested to be printed or there is a hiccup in the process the pc looses the priority in the print list ( page number or new document)and so backs up that memory and becomes blocked
by going into the pc in the printer hard ware and deleting the printing waiting to be processed your are unblocking the process and allowing the pc to again move data to be printed

Sounds like a bad print job stuck in a print spooler.
Turn off copier. Go around to all computers that print to it and open the print queue. delete all print jobs. reboot each PC. Power up copier and see if it clears

Hi

replace printhead or replace printer.. the cost of printhead is to high

Pls vote us to keep us alive

cancel the printing... on control panel double click the printer.... double click the model of your printer to display pending printing process.. then cancel print.

Enter the service mode, do the data clear, the problem will solved out

Green light flashing means printer is in printing process. No problem. If you want to stop printing. delete printing job from printer properties or stop printing from status monitor.

If it is solid on, it means the printer is ready to print; no action is required. If it's flashing, it means the printer is processing data and should print soon.

If you are printing from your computer and nothing comes out, with the "Horseshoe" light staying solid, I suggest checking the connection between your computer and the printer, or at least the printer configuration. Most of the time, unplugging, then plugging cables back in does the trick.

Try putting a piece of paper in tray 1

From the OKI site, I found this information. My problem is a Flash 2 Blink, which is a problem with the cover or minor error, whatever that means. I can't figure out how to fix it. Any suggestions greatly appreciated!

Flash type Ready LED (Green) Manual feed LED (Amber) Error LED (Amber) Meaning Flash 1 -- slow blink X The printer is processing data when printing has been suspended. X The image drum required changing or toner is low. Flash 2 -- blink X The printer is receiving and processing data during printing or the printer is resetting itself. X The printer is requesting manual paper feed. X There is a printing error, problem with paper or a cover open. X X X There is a minor error with the printer. Flash 3 -- rapid blink X X X There is a major error with the printer.