Lhs616w sensor not working

It's possible that one of the newer sensors could work in place of your 1457 sensor, but it depends on the specifications of the newer sensors and the compatibility with your base unit. The I MAX1457 sensor, which is a highly integrated analog-sensor signal processor optimized for piezoresistive sensor calibration and compensation. However, I have no information about its compatibility. If you're looking for a replacement sensor, I suggest contacting the manufacturer of your base unit to inquire about compatible sensors. Alternatively, you can check the user manual of your base unit to see if it lists compatible sensors. Garage door opener sensors are not universal. Safety sensors can only communicate with garage door openers from the same brand.

Is this a TV question?

which sensors I guess there a several sensors , temperature sensors , level sensors, speed sensors e.t.c .are all sensors not working? check the earth / ground / common of your vehicle maybe there is a shot circuit.

P1121 GMC - Throttle Position Sensor Circuit Intermittent High Voltage
This codes has nothing to do with APP - accelerator pedal position sensor . This has to do with the throttle body - TPS throttle position sensor . These have know problems ,the sensor an broken wire at throttle body , an when this happens the cruise control wont work . The throttle works by a DC motor controlled by the PCM - engine computer .

cruise controls are dependent on the following sensors all working together
brake sensor
clutch sensor
auto--vehicle speed sensor
rpm's sensor
fuse for the cruise control
cruise control switch either or all not working will stop the cruise control from engaging
road speed at which you can engage the cruise control has to be above a reset speed before it will cut in and work

Which kind of sensors? The auto start sensors? If the shredder non stop working you can try clean it. You must open cover, replace cutting module and clean sensors. If this doesnt work after it, you must remove sensors.

my vaio VGN-CS26G' touch sensor panel doesn't work after install Windows 7
please help the basic is Windows Vista after i change it in to Windows 7 touch sensor panel doesn't work

Maybe the antitheft system. Read thru this link

http://vatspasslockpasskeysecurityhelp.yolasite.com/

RPM SENSOR:
indicates input signal from the RPM sensor to the MCB.If the LED, is not flashing, please review the following:
1) Sensor disconnected from the MCB.
2)RPM SENSOR misaligned.
3)RPM sensor faulty.

e.cuadra

run abs codes .speed sensor works with wheel sensors,could be electrical or wheel sensor