My whirlpool duet front load washer is flashing F35 and suds. It should fix on its on after 5 minutes but it turns off. what can i do?
F35 is a water level error.
The water level switch (pressure switch) has malfunctioned.
If you remove the top panel, three screws in the back, you will have access to the pressure switch.
With the tub empty, remove the vinyl hose from the switch and blow backwards through the hose to clear any restrictions.
If the fault codes return after doing this, you will likely need to replace the pressure switch.
Also - please be sure to use He soap.
Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.####
What does blow backwards mean (like **** in ?)...and how do you remove the hose from the switch ? does it screw off or just pull it really hard ?
I have done this and still getting same error.. Any ideas? All hoses, filter and drains checked.. New pressure switch....and still sud at start of cycle and dies... Ther Eli's no soap in it I have run water thru soap dispenser... Out of ideas.. Hep someone
×
Outside the normal analog pressure sensor (APS) / hose checks...
Another cause for the F35 and SUD error could be your CCU (control unit). There are components that seem to fail over time and cause the F35 and SUD errors. You can replace those components yourself now...
See f35 error for more information.
I hope this helps and let me know if you need anything else!
Hello & Welcome to FixYa
F35 error means that there is some sort of issue
with the steamer electronic board and analog pressure sensor has gone bad.
Check that the hose is firmly attached with the washer and is not blocked. You
can also check the water level pressure switch operation. Please get back to me
if you have any other questions.
Kevin
770 views
Usually answered in minutes!
×