HI, you will need to check the terminal block. this is where the power cord runs to on the back side of the unit. make sure it is not lose or worn. you may have to disassemble the unit to expose the terminal block in this case. the power cord wires will spit into three or four little wires and, they will either be soldered or screwed on the block. make sure these wires are secure and not ripped or worn.
Now, if the terminal block is in good condition, this will confirm power board failuer and, in this case, you will need to replace the board supply board .
Hi,
There
are many reasons why a dehumidifier will not work or collect water.
Here
is a tip that I wrote to help people to figure out what is going
wrong with their dehumidifier
Dehumidifier
is running but no water is in bucket
heatman101
258 views
Usually answered in minutes!
Thanks for your help and suggestions. I did check the cord wires and their are fine suggesting the problem is elsewhere. Could you please explain and/or identify the board supply? Is this the entire board where all the connections and wires are plugged to?
Thanks
×