Maytag mah5500bww washer

Yes this can be a touch pad failure that may need to be replace again , because with this type of device usually the touch pad is easy to get bad...

Good luck........

download from here
Maytag MAH5500BWW Neptune Series 27 Front Load Washer Manual

Sounds like control board is defective

The machine control pad, with the LED lights, is going out. Replace this control pad and all lights should be working normally again.


I’m happy to help further over the phone at https://www.6ya.com/expert/jeremy_69f3cc28d95bf514

If your washer doesn't seem to work at all, check these:

No power
Lid switch
No power Check to see whether power is getting to the washing machine. Is it plugged in? Has a fuse blown or is a circuit breaker tripped?

Lid switch If the lid switch is defective, your washer can't spin and may not function at all. The switch is inside the washing machine main housing near the door frame. Often you have to raise or open the top or front of the washer to get to the switch. If it's defective, you need to replace it.

Some machines have a special lid-switch fuse near the lid switch, inside the control panel. If this fuse blows, the unit won't fill with water until you replace the fuse.

I had a similar problem on my Neptune. All the machine would do is beep. I believed it was a stuck button so I got a new touch pad and that solved the problem. I also substituted a control board prior to buying the touch pad but the problem was the same.

i have maytag neptune wash,modelo mah5500bww,my problem is: no starting,flashing start/pause button,after ten minutes is off.And now is ready for start when press start/pause button

Replace control board