Pentair intelli flo vs+Svrs no display - Pentair IntelliFlo VS-3050 & VS+SVRS Variable Speed Pump -

go to utube look for video on progamming that pump it helped me

is pump hooked up correctly see instructions if 240 volt or 120 volt

check incomming voltage and switch

check the back of the pump motor wires are probably wet

Which part of the housing?
The back against the motor or against the strainer basket housing?
Parts break down for the Pentair IntelliFlo VS-3050 here.
If leak is on the back of the housing - shaft seal. Or if the leak is on the front the replace O-Rings #10 or #23 in diagram.

The Intelliflo SVRS will do this everytime. The SVRS part of the model indicates that it has a Safety Vacuum Release System integrated into the pump. This means that whenever the pump senses a change in the vacuum pressure (when you connect your barracuda this happens) the SVRS kicks in and shuts the pump down.
If you want to avoid this, you either need to disable the SVRS in the intelliflo menu, Or simply push the "quick clean" button and it will run constantly with no SVRS for 1 hour.
Below is the link for the manual on this pump, this will tell you how to disable the SVRS function if the 1 hour quick clean is not sufficient time to clean your pool



http://www.pentairpool.com/pdfs/IntelliProVS+SVRSOM.pdf

This pump cannot work with a mechanical timer alone.You would need to use a pentair controller to use this in the fashion that you desire. The intellicomm P/N: 520641 is the cheapest way to accomplish this feature. However, if you have the intelliflo vs-3050 WITH SVRS then you simply need to program the timer to come on and off when you want it to. If you have only the VS-3050 with no SVRS , then you need the intellicomm module. Just incase you have the vs-3050 with SVRS, I will post the link for the manual so that you know how to program the timer. Any other questions, im @ [email protected]

http://www.pentairpool.com/pdfs/IntelliProVS+SVRSOM.pdf

On the normal vs-3050, you need to reset the whole unit. You do this by holding all 4 speed buttons for 30 seconds. After thi, shut off the power at the breaker. let sit for 2 minutes. Restore power and all setting are reset. I cant find any information about the SVRS model, but it should work the same way.