I Have used one befor

Sounds like you have a low battery.

Hi Terry,

If you can see the faint picture in flash light means the power supply and the main board is working. The real culprit is the backlight. Even one bad LED in the backlight will switch off the whole array. To repair this fault the panel has to be opened and the defective LED or LEDs are to be replaced.

This is a complicated, delicate and risky job and must be attempted by an expert only. You may end up damaging the screen permanently if you have not done it before and try to DIY.

What is model & year of the mower ?

your phone firmware is crashed you need to repair it using kies.or just bougt it to professtional one if you don't do it in your own way.

How about the battery

You do hear a faint ticking
That is the starter solenoid
The solenoids contacts could be
burnt,even though you had the starter
tested.

Make sure that BOTH ends of the battery
cables are CLEAN & TIGHT

Hi,
First make sure that the cartridges are OK and have enough toner. (Remove the cartridges and inspect it physically, shake it horizontally so that the toner inside the cartridge is evenly distributed) If it happens even if the cartridge has enough toner or after replacing the toner cartridge, it is most likely be due to dust accumulation at the laser reflecting mirrors inside the printers, which partially blocks laser beams and results in faint print. Therefore the printer requires cleaning/ servicing by a professional.

GoodLuck!
Dont forget to appreciate the solution if I could have been of any help!
CreativeTECH

clean and, reinstall your battery cables on the battery

the only thing this could be is the backlight inverter has failed. you would be better getting a cost on the part and repair before you go ahead.

I've seen a similar looking problem and it is a bad LCD panel. It will show even on a non-used input, and will show through the menu screen and the screen saver, also. Sharp's LCD panels are very expensive,too. Over 4000 at encompassparts.

I have the exact same problem. I believe we need Part # MLT386X PCB according to the other posts. It's around $179.