Batteries are charged disconnected and used seperate charger thet had 3/4 charge to start with push start button nothing wheels locked but when charger is plugged in controller lights light up showing

Lock System Does Not Lock
Step
Action
Yes
No
DEFINITION: The lock system will not allow the key to be turned to the OFF lock position.
1
Did you review the Steering Wheel and Column - Tilt Description and Operation and perform the necessary inspections?
Go to Step 2
Go to Symptoms - Steering Wheel and Column - Tilt
2
Verify that the lock system does not lock.
Does the lock system operate normally?
System OK
NO - Go to Step 3
3
Inspect for a faulty lock cylinder or release button.
Is the lock cylinder or release button damaged?
Go to Step 6
Go to Step 4
4
Inspect the shift linkage adjustment.
Is the shift linkage adjusted incorrectly?
Go to Step 7
Go to Step 5
5
Inspect the ignition switch for damage.
Is the ignition switch damaged?
Go to Step 8
Go to Step 6
6
Replace the lock cylinder. Refer to Ignition Lock Cylinder Replacement - On Vehicle .
Did you complete the repair?
Go to Step 10
--
7
Adjust the shift linkage.
Did you complete the repair?
Go to Step 10
--
8
Replace the ignition switch. Refer to Ignition Switch Replacement - On Vehicle .
Did you complete the repair?
Go to Step 10
--
10
Operate the system in order to verify the repair.
Did you correct the condition?
System OK
Go to Step 3

Question edited for clarity, full make model (what it is).

Did you follow Section 9 about fully charging the battery, pressing and holding the button?

Charging Instructions 1. Plug the charger into the mains - the charger indicator light will be green.
2. Turn on the battery by press and holding the power button until the green light is illuminated.
3. Plug the battery into the charger. The charger light will turn from green to red to indicate the charging process has started.
4. Once the battery is fully charged, the charger status light will be

https://www.powakaddy.com/wp-content/uploads/2021/02/LATE-2022-FX3-OWNERS-MANUAL_01b.pdf

If that doesn't fix it, it will be a warranty issue. Click Support on top left.

https://www.powakaddy.com/manuals-and-instructions/

..

Try the follow to see if it will fix it:
There is a power reset button near the charging port. It looks like a tiny hole. While plugged into the charger, use a paperclip to push the button inside this hole for 3-5 seconds. If it turns on, please allow it to charge for 4-6 hours before using it. If you leave it on the charger for longer than the allocated time, you will go back to having the same problem as before. If the power does not come on, please leave it plugged up for 4-6 hours then disconnect it from the power and turn it on.

If your tablet does not have the reset button: With the tablet plugged into the charger, hold the power button for 10 seconds then click the volume up once. If it turns on, please allow it to charge for 4-6 hours before using it. If you leave it on the charger for longer than the allocated time, you will go back to having the same problem as before. If the power does not come on, please leave it plugged up for 4-6 hours then disconnect it from the power and turn it on.

After performing the power reset on the device the device will behave in one of the following ways:
1. The tablet will turn on like normal.
2. The tablet will show the battery icon only.
3. The tablet will show nothing on the screen at all.

All of these are normal for the device and should not be cause for alarm. If the device still fails to power on after being left on the charger for 4-6 hours,

Then most likely the battery will need replacing.

Here is a link to where you might be able to get a new battery:


Replacement 4000mah Battery for Kocaso M9100 M9000 9 MID All Winner A13...

Use an automotive NON automatic style to charge the batteries individually. This may tale up to 72 hrs. to get the voltage up tp at least 10 volts. When that happens, the regular battery charger made for the scooter will finish off the charge. If the battery won't take a charge, then they're history.

Hi, so it telling you it's charging however the scooter shows no charge once the charger is disconnected ???

1. First of all , is it possible to try another charger ? or test on another scooter.

2. If the charger proves to be okay, it's starting to look like the fault is with the batteries themselves, batteries can fool certain chargers into thinking they being charged when it fact the resistance inside the batteries have become too great.. They need replacing,...

3. Another issue could be the charger socket or the charging circuit to the batteries..
( is there a fuse ? )

Regards
Rob

www.gewizrepairs.co.uk

Hi Linda. Sometimes if there is a blown fuse or faulty connector on the battery leads, the charger thinks the batteries are charged as the voltage coming out of the charger rises to the high level. Some chargers will cut out if this happens. It is probably not the charger.
Make sure the batteries are plugged in correctly, sometimes during transport they will get knocked and become disconnected.
Also make sure that the battery terminals are not loose where the wires connect to the batteries.
Good luck. Neil.

Visit:Peeplo.com/Free+Repair+Manual & im almost sure as i have a disability scooter when its not in use use a decent trickle charger they can be left plugged in for up to 3 months,so your batteries are fully charged all the time & plug back in even if you do a 100 yards trip,lets be honest the batteries are not cheap,so get the most out of them.or if not in use for any period after they are fully charged disconnect them.

3 months is too long for gel batteries to sit off-charge, without being fully charged first, then disconnected before storage.

Your charger is trying to charge, but the batteries aren't cooperating. This chair accepts either the Group 22 or Group 24 gel-sealed batteries. 22 are about 50 amphour, and 24 are about 74 amphour, and will give you greater range. Cost for a set of two of either is going to be about $350 and $450 respectively. Ouch!

May be the battery won't have charge, keep 1 or 2 hrs continues charges, and if it is not working then you have to replace the battery set full.

Check the fuses may have a Blown fuse

Check to see if power supply witch charges the scooter is not faulty

Regards; Aaron