Display lights all on

Likely to be the clutch or gearbox wear.

Hi Yvemarie,
Based on what I searched about the machine that you have where in the beep noise can only be hear at the end of the cycle not during the cycle. And also that noise can lower down and I will provide you steps on how to do that. It seems to me also that there is some kind of an issue on your machine since you said there was steaming and smoking happening, right? If the steps I will provide below works and still doing the same thing I guess you need to have that machine serviced.

1. • 1 Press and hold the "Select" button on the electric display until the acoustic signal symbol, which looks like a small speaker-phone, is illuminated on the display.
     
   • 2 Continue to hold down the "Select" button until the system cycles through "Continuous", "Max" and then "Off" settings.
     
   • 3 Release the "Select" button when "Off" is highlighted next to the acoustic symbol. The signal noise is now turned off on the washer.
     

Read more: How to Silence a Bosch Washing Machine ' eHow.comhttp://www.ehow.com/how_7552735_silence-bosch-washing-machine.html#ixzz1fRDAKHrO

Sounds like you've got a thread jam going on in the bobbin case area. Good cleaning and a new needle will probably fix it. See: https://answers.yahoo.com/question/index?qid=20091202121550AAHxN8y

Could you please describe the problem you are having a little better?

Check fuses end relays. Fuse could be blowin. If the lights don,t come on on the heater control panel for the different funtions, Mostly the fuse has (Blowin)

try these suggestions
change the needle
rethread the machine top & bobbin
make sure to use every thread guide
make sure the bobbin is not damaged or warped
make sure the bobbin is not over full
make sure the bobbin is inserted correctly into the bobbin case
make sure the bobbin case fits securely into the machine unless it's
a drop in bobbin
if these suggestions don't help then the machine may need to be
checked at a repair shop

I can be of help please email me [email protected]
An upgrade can be offered, with lower call rates.

First of all you need to find a new garage that isn't just telling you what they don't know. If it were just a filter they would have replaced it and watched you drive away with a smile on your face. There is nothing better than a happy customer. The other thing is that you don't mention if the ****** is a manual or automatic. The ****** could be a bunch of different problems depending on type of ******. Also Volkswagen's are noted for many sensor problems. There are many sensors that can throw a code if they even malfunction for a second. Wish I could help more, but the information is to vague.

Hi
check the fuse box for fused fuse and replace them with the corresponding fuses.
Regards.

in the middle of sewing the machine made a loud noise and then would not run just chaters when you push the start button its like it is jambed the model is cs80