I bought a small alloy helicopter and it won't respond to the remote control on any of the channels and it is fully chargesuggestions as d, any to what to do?

SOURCE: Batteries installed - charged as

Hello

I have the exact same model you are having problems with. Just a few questions to clarify:

Does the red light flicker in on the circuit?
Also, is the remote turned on?

Let me know about the above described. I will come back top you as soon as possible.

Kind regards
Lock123

SOURCE: Bought a S108 helicopter. Charged

There should be a sticker near the helicopters "on off" switch that has an "A" "B" or "C" on it. Make sure the switch on the controller is set to correspond with that letter. If that isnt it, keep it for parts and buy another. These are VERY delicate toys and most break quite easily.

SOURCE: The helicopter syma s032 not

0) Obviously, helicopter will operate best when fully charged... if charging light gets brighter when unplugged from helicopter, then it's not at full charge. Charge fully, then allow battery to cool for 10 minutes. Good batteries in remote also.
1) Power on helicopter.
2) Place on level surface and let gyroscopes sync. There is a red light inside the body (NOT the red/blue flasher in the nose) that will blink when you turn helicopter on, and will keep blinking until craft is level and stable for a few seconds, then will stop blinking.
3) Make sure left joystick is all the way down.
4) Power on remote.
5) Throttle up (left joystick) until blades move and then all the way back down.
This should get you flying. Let me know.

hope this helps,
r