Copystar CS-2550 Set up add'l scan folders - need to reset psswrd

see link below for cs2550 support/downloads

Push the System Menu/Counter Button
Using arrow keys find the Machine Default-press enter
Use the factory set PIN (should be 2500)-press enter
Arrow to PIN# change-press enter
Using key pad choose new number-press enter then press the reset button

No it can not. This is an older scan system.

Below is a link to Copystar's website where you can download the CS-2550 print driver.

http://usa.copystar.com/americas/jsp/Kyocera/resource_details.jsp?pid=13704&rid=22655

I hope this is helpful,
Shawn

goto usa.copystar.com and search in downloads...

I’m happy to assist further over the phone at https://www.6ya.com/expert/norman_d2fa496dce30c65d

bad fuser... replace it...

I’m happy to assist further over the phone at https://www.6ya.com/expert/norman_d2fa496dce30c65d

ok... I am tech... and I had the same problem... you need to install the generic postscript driver then goto this ip address (http://localhost:631)and tune the driver... if not you will only print from tray 1 and only a4 paper size...

I’m happy to assist further over the phone at https://www.6ya.com/expert/norman_d2fa496dce30c65d

I do not know much about the situation but, I'll give it a try. First turn the pwr off to the scanner and try to ping agian just to make sure you are not trying to use an ip adress that is aleady being used. You should not recieve a responce untill you turn the power back on but, if you do get a reponce while the scanner is off change the ip adress on the scanner. Next if that did not help, you will need a correct path to your computer from the scanner like example( \\server\public\scans ) next you will need a username and password to gain access to the shared folder..

hi 
the drum unit on this model has two plugs which need to be plugged in and one on the dev unit that can come loose.
also the metal mechanism under the dev unit has to be pushed in to enable toner to get onto the drum.
is the transfer roller fitted correctly?

yes you can !
turn OFF the copier and unplug the power cord and the network cables!! Take off the scanner board - there is a jumper to reset the scanning system to default factory settings. Install the scanning system and power the copier. Wait till is Ready to Copy + 2 minutes. turn OFF and unplug the power cable, restore the jumper on the scanning system board. Put it back and power up.