- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Step 1
Step lightly on the scale until it displays "--", "0000" and turns off if you receive the error "ERR0," which means the scale is not initialized. Initialization must occur after each battery installation.
Step 2
Set the scale on a flat, even surface, not on surfaces such as carpet if you receive an error "ERR1."
Step 3
Step off the scale and wait for it to reset before stepping on it again if you receive an "ERR2," which often means the unit was jarred or overloaded. Also, if you weigh more than the maximum weight capacity you will receive this error.
Step 4
Remove your shoes and socks and wet your feet slightly with a damp cloth if you receive the "ERR3" error. ERR3 is a contact error and your feet should ideally be bare and wet to achieve an accurate body-fat reading.
Step 5
Step off the scale and wait for it reset. Remove your shoes and socks and wet your feet slightly if you receive either the "ERR4" or "ERR5" errors, which means your body-fat or body measurements are out of range.
Step 6
Reset the scale if it doesn't work or you continue to receive error messages. Remove the battery and set the scale on a flat surface. Stand still on the scale for five seconds and step off. Re-install the battery and place the scale back on the flat surface. Place one foot on the scale until it displays zeros or dashes. Remove your foot and wait for the scale to turn off. Step back on the scale to weigh yourself.
Step 7
Replace the battery if you receive a "lo" or "bat" error.
I couldn't find a manual on the internet either.
You could try these 'resources' though
Visit the detecto official website (I couldn't find the manual there) and use the support tab at the left edge of thar page or find contact details and ask detecto for a manual. http://www.detecto.com/
I think detecto have a facebook page. Login to facebook and go to https://www.facebook.com/cardinaldetecto/posts/10151307170136769 (I'm not sure that you have to be logged in but I w3as and went straight to that page). It is about problems with a D220 AND HAS CONTACT DETAILS FoR YOUR PROBLEM (from 2013 though)
finally if do get a manual upload it to the fixya manuals collection
Instructions are there to assemble the scale and that should help. Otherwise you can call the folks at Wholesale Point. They are authorized dealers and know the products very well.
×