What is the radio code for hyundai elantra 2002
SOURCE: 2002 Hyundai Elantra Check Engine
the error was resolved in the link below, please check the last post of Sith.
http://www.hyundai-forums.com/t28310-1997-elantra-code-p0455-help.htm
hope this will help you resolve th issue you have too.
SOURCE: P0139 code for a 2003 hyundai elantra. What is this code?
Hi the code P0139 is Bank 1 sensor 2 lambda sensor fault ,possible wiring or sensor fault even if you replace the sensor you need to have the MIL lamp turned off by a Diagnostic machine,it is possible you have another fault such as poor Catalytic converter efficency giving the same fault code ,Would recomend you get the car checked and read the "live" data as the car see`s it to make an accurate diagnosis and cure
SOURCE: 2002 hyundai elantra radio and dome light not working
Then 1, bulbs are burned out
OR 2, the wiring is faulty.
Testimonial: "thanx for the solution. took the car to a repair shop and was told that the wiring was faulty. had the car rewired."
SOURCE: 2003 Hyundai Elantra GLS. Check engine light, code PO133
Did you use a aftermarket O2 sensor or a genuine Hyundai one? If it's an aftermarket one it may be bad or not as good as the OEM one. See here for more details and other potential causes: P0133
SOURCE: how to replace 2002 hyundai elantra hub and bearing
With the car on ground, break loose the drive-axle nut, and the wheel nuts , than jack up the car, support it properly, remove the wheel ,remove the axle-nut.
Remove the brake caliper assembly-- support it properly.
Remove the two bolts that hold the hub bracket to the Macpherson strut assemble, remove the lower arm ball joint and remove the steering tie- rod ball-joint attached to the hub bracket. That's it.Slide off the hub /with the bracket off the drive-shaft.
Follow steps backwards to assemble back.
38 views
Usually answered in minutes!
×